11-01-0101 Molex Inc, 11-01-0101 Datasheet - Page 4

• Manufacturer Part Number: 11-01-0101
• Description: HTR2450A HANDTOOL
• Manufacturer: Molex Inc

Specifications of 11-01-0101

• Tool Type: Hand Crimper
• Features: Side Entry
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• For Use With/related Products: Terminals, 14-20 AWG
• For Use With: WM2684CT - CONN FEMALE FLAT BLADE 14-22AWGWM2684TR - CONN FEMALE FLAT BLADE 14-22AWG
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 0011-01-0101; 0011-01-0101-E; 0011010101; 0011010101-E; 11-01-0101-E; 11010101; 11010101-E

Hand Crimp Tool for Flat Blade Female Crimp Terminals
Doc No: ATS-011010101
Revision: E
How to Adjust Tool Crimp Force
It may be necessary over the life of the tool to adjust tool-crimping force. Listed
below are the steps required to adjust the crimping force of the hand tool to obtain
proper crimp conditions:
1. Loosen the stud nut on the back of the handle.
2. With a screwdriver in the slot on the other side of the stud, adjust the force.
3. Retighten the nut.
4. Check the crimp specifications after tool force adjustment.
Warranty
This tool is for electrical terminal crimping purposes only. This tool is made of the
best quality materials. All vital components are long life tested. All tools are warranted to be free of
manufacturing defects for a period of 30 days. Should such a defect occur, we will repair or exchange the tool
free of charge. This repair or exchange will not be applicable to altered, misused, or damaged tools. This tool is
designed for hand use only. Any clamping, fixturing, or use of handle extensions voids this warranty.
CAUTIONS:
1. Manually powered hand tools are intended for low volume or field repair. This tool is
2. Insulated rubber handles are not protection against electrical shock.
3. Wear eye protection at all times.
4. Use only the Molex terminals specified for crimping with this tool.
Notes:
1. This tool should only be used for the terminals and wire gauges specified on this sheet.
2. This tool is not adjustable for crimp height, however crimp force is adjustable (See instructions above).
3. This tool is intended for standard conductor sizes. It may not give a good insulation crimp support for all
4. Molex does not repair hand tools (see warranty above) The replacement parts listed are the only parts
5. Pull force should be used as the final criteria for an acceptable crimp. Pull force is measured with no
6. Molex does not certify crimp hand tools.
Clockwise will increase the force, counter clockwise will decrease the force.
production use. Repetitive use of this tool should be avoided.
Variations in tools, terminals, wire stranding and insulation types may affect crimp height.
insulation sizes.
available for repair. If the handles or crimp tooling is damaged or worn, a new tool must be purchased.
influence from the insulation crimp. The insulation should be stripped long (1/2 in.) so the insulation grips
on the terminal do not grip the wire insulation or the conductor. Refer to Molex Quality Crimping
Handbook 63800-0029 for additional information on crimping and crimp testing.
CAUTION: Molex crimp specifications are valid only when used with Molex terminals and tooling.
Release Date: 11-29-04
Revision Date: 04-21-08
CAUTION: Repetitive use of this tool should be avoided.
(See Figure 3)
UNCONTROLLED COPY
NOT
ECCENTRIC
STUD
intended for
Figure 3
Page 4 of 5