AMSR-7805-NZ Aimtec Inc., AMSR-7805-NZ Datasheet - Page 3

• Manufacturer Part Number: AMSR-7805-NZ
• Description: DC/DC SWITCHING REGULATOR
• Manufacturer: Aimtec Inc.

Recommended Circuits
Conducted and Radiated Emissions
NOTE: 1.
by Aimtec; refer to www.aimtec.com for the most current product specifications.
date manufactured.
nominal input voltage and at rated output load unless otherwise
and chemicals at the time of publishing this document. CAS numbers and other limited information are considered proprietary and may not be available for release.
product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control systems or other such applications which necessitate
specific safety and regulatory standards other the ones listed in this datasheet.
www.aimtec.com
F 051e R6.C
Standard Application Circuit
GND
Vin
C1: A low ESR capacitor is required to keep the noise of the converter to a minimum.
Ceramic capacitors are recommended, but tantalum or electrolytic may be used. Typical value is 10µF / 50V.
C2: Installation of C2 is recommended but optional. Typical recommended value is 100µF / 25V electrolytic.
NOTE: This part is not designed for parallel operation
10µF
Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled
C1
3.
Mechanical drawings and specifications are for reference only.
1
AMSR - 78XX- NZ
2
specified.
3
5.
Tel: [phone]
Aimtec may not have conducted destructive testing or chemical analysis on all internal components
100µF
C2
7.
2.
Warranty is in accordance with Aimtec’s standard Terms of Sale available at www.aimtec.com.
Product labels shown, including safety agency certifications on labels, may vary based on the
3 of 3
Vout
4.
GND
All specifications are measured at an ambient temperature of 25°C, humidity<75%,
Up to 7.5Watt | DC-DC Converter
Series AMSR-78-NZ
Toll free: + 1 888 9 AIMTEC
North America only
6.
(924 6832)
This