XC5VSX95T-1FF1136I Xilinx Inc, XC5VSX95T-1FF1136I Datasheet - Page 57

• Manufacturer Part Number: XC5VSX95T-1FF1136I
• Description: FPGA Virtex®-5 Family 94208 Cells 65nm (CMOS) Technology 1V 1136-Pin FCBGA
• Manufacturer: Xilinx Inc
• Series: Virtex™-5 SXTr

Specifications of XC5VSX95T-1FF1136I

• Package: 1136FCBGA
• Family Name: Virtex®-5
• Device Logic Units: 94208
• Typical Operating Supply Voltage: 1 V
• Maximum Number Of User I/os: 640
• Ram Bits: 8994816
• Number Of Logic Elements/cells: 94208
• Number Of Labs/clbs: 7360
• Total Ram Bits: 8994816
• Number Of I /o: 640
• Voltage - Supply: 0.95 V ~ 1.05 V
• Mounting Type: Surface Mount
• Operating Temperature: -40°C ~ 100°C
• Package / Case: 1136-BBGA, FCBGA
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With: HW-AFX-FF1136-500-G - BOARD DEV VIRTEX 5 FF1136
• Number Of Gates: -
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Virtex-5 FPGA User Guide
UG190 (v5.3) May 17, 2010
Dynamic Reconfiguration Ready Output - DRDY
Table 2-4: DCM Status Mapping to DO Bus (Continued)
When LOCKED is Low (during reset or the locking process), all the status signals are
deasserted Low.
The dynamic reconfiguration ready (DRDY) output pin provides the response to the DEN
signal for the DCM’s dynamic reconfiguration feature. Further information on the DRDY
pin is available in the dynamic reconfiguration section in the Virtex-5 FPGA Configuration
Guide.
DO[3]
DO[15:4]
DO Bit
CLKFB stopped
Not assigned
Status
www.xilinx.com
Asserted when the feedback clock is stopped (CLKFB
remains High or Low for one or more clock cycles). The
DO[3] CLKFB stopped status is asserted within six
CLKIN cycles after CLKFB is stopped. CLKFB stopped
will deassert within six CLKIN cycles when CLKFB
resumes after being stopped momentarily. An
occasionally skipped CLKFB does not affect the DCM
operation. However, stopping CLKFB for a long time
can result in the DCM losing LOCKED. When LOCKED
is lost, the DCM needs to be reset to resume operation.
When the DLL portion of the DCM is not used (for
example, when using CLKFX output only), the CLKFB
can be left unconnected. In this case, DO[3] is
deasserted.
Description
DCM Ports
57