4307-52 Peregrine Semiconductor, 4307-52 Datasheet - Page 3
![no-image](/images/no-image-200.jpg)
4307-52
Manufacturer Part Number
4307-52
Description
IC DSA 5BIT 50 OHM 20-QFN
Manufacturer
Peregrine Semiconductor
Series
UltraCMOS™r
Datasheet
1.4307-52.pdf
(11 pages)
Specifications of 4307-52
Attenuation Value
15.5dB
Tolerance
±0.15dB
Frequency Range
0 ~ 2GHz
Impedance
75 Ohm
Package / Case
*
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
1046-1034-2
PE4307
Product Specification
Evaluation Kit
The Digital Attenuator Evaluation Kit was designed to
ease customer evaluation of the PE4307 DSA.
J9 is used in conjunction with the supplied DC cable to
supply V
negative voltage generator is desired, then connect –
V
is desired, then apply -3V.
J1 should be connected to the LPT1 port of a PC with
the supplied control cable. The evaluation software is
written to operate the DSA in serial mode, so switch 7
(P/S) on the DIP switch SW1 should be ON with all
other switches off. Using the software, enable or
disable each attenuation setting to the desired
combined attenuation. The software automatically
programs the DSA each time an attenuation state is
enabled or disabled.
Note: Jumper J6 supplies power to the evaluation
board support circuits.
To evaluate the Power Up options, first disconnect the
control cable from the evaluation board. The control
cable must be removed to prevent the PC port from
biasing the control pins.
During power up with P/S=1 high and LE=1, the default
power-up signal attenuation is set to the value present
on the five control bits on the five parallel data inputs
(C0.5 to C8). This allows any one of the 32 attenuation
settings to be specified as the power-up state.
During power up with P/S=0 high and LE=0, the control
bits are automatically set to one of two possible values
presented through the PUP interface.
values are selected by the power-up control bit, PUP2,
as shown in Table 6.
Pins 1 and 7 are open and may be connected to any
bias.
Document No. 70-0161-04 │ www.psemi.com
DD
(black banana plug) to ground. If an external –V
DD
, GND, and –V
Note: Resistor on pin 3 is required and
should be placed as close to the part
as possible to avoid package
resonance and meet error
specifications over frequency.
DD
. If use of the internal
These two
DD
Figure 4. Evaluation Board Layout
Figure 4. Evaluation Board Layout
Peregrine Specification 101/0112
Figure 5. Evaluation Board Schematic
Peregrine Specification 102/0142
©2003-2006 Peregrine Semiconductor Corp. All rights reserved.
Page 3 of 11