88019-37 AVX Corporation, 88019-37 Datasheet - Page 2

• Manufacturer Part Number: 88019-37
• Manufacturer: AVX Corporation

Specifications of 88019-37

• Lead Free Status / RoHS Status: Supplier Unconfirmed

multilayer ceramic capacitor networks.
include documents cited in other sections of this specification or recommended for additional information or as examples. While every
effort has been made to ensure the completeness of this list, document users are cautioned that they must meet all specified
requirements of documents in sections 3 and 4 of this specification, whether or not they are listed.
document to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation
or contract.
Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
document and the references cited herein, the text of this document takes precedence. Nothing in this document, however,
supersedes applicable laws and regulations unless a specific exemption has been obtained.
(see figure 1).
capacitor components and solder shall not exceed 97 percent, by mass. Tin shall be alloyed with a minimum of 3 percent lead, by
mass
DEFENSE ELECTRONICS SUPPLY CENTER
1. SCOPE
1.1 Scope. This drawing, MIL-PRF-39014, and
1.2 Part or Identifying Number (PIN). The complete PIN shall be as follows:
2. APPLICABLE DOCUMENTS
2.1 Government documents.
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this specification. This section does not
2.2 Government documents.
2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and handbooks form a part of this
DEPARTMENT OF DEFENSE SPECIFICATIONS
DEPARTMENT OF DEFENSE STANDARDS
2.3 Order of precedence. Unless otherwise noted herein or in the contract, in the event of a conflict between the text of this
3. REQUIREMENTS
3.1 Interface and physical dimensions. The interface and physical dimensions shall be as specified in
3.1.1 Leads. Leads shall be as specified on figure 1.
3.1.2 Case. Molded or conformally coated.
3.1.3 Pure tin. The use of pure tin, as an underplate or final finish is prohibited both internally and externally. Tin content of
(Copies of these documents are available online at
(see
MIL-PRF-39014
MIL-PRF-39014/5
MIL-STD-202
MIL-STD-1285
6.3).
DAYTON, OHIO
-
-
-
-
Capacitors, Fixed, Ceramic Dielectric (General Purpose) Established Reliability and
Nonestablished Reliability, General Specification for.
Capacitors, Fixed, Ceramic Dielectric (General Purpose), Established Reliability, Styles
CKR11, CKR12, CKR14, CKR15, and CKR16.
Electronics and Electrical Component Parts.
Marking of Electrical and Electronic Parts.
MIL-PRF-39014/5
Drawing
number
88019-
https://assist.daps.dla.mil/quicksearch/
describe the complete requirements for single-in-line packaged
Dash number
(see table
SIZE
A
XX
I)
CODE IDENT NO.
REV H
14933
or from the Standardization Document
MIL-PRF-39014
PAGE
DWG NO.
88019
and herein
2