DEMOQE128 Freescale, DEMOQE128 Datasheet - Page 17

• Manufacturer Part Number: DEMOQE128
• Manufacturer: Freescale

Specifications of DEMOQE128

• Lead Free Status / RoHS Status: Compliant

DEMOQE128 User Manual
7. Click “ Finish.” In the background CodeWarrior will transform your
8. If the Logic Analyzer utility is open, click the “ Close Port” button on
9. Turn the board power switch to OFF.
10.
11.
12.
13.
14.
15.
16.
project to the 32-bit microcontroller with no software changes needed.
An informational “ Project Messages” window may appear letting you
know that changes have been made to the project.
that utility.
Switch the green 8-bit S08 daughter card with the red 32-bit Cold-
Fire V1 daughter card. Make sure to align pin 1 (as marked by
arrows) on the daughter card with pin 1 on the board.
Turn the board power switch to ON.
Compile the transformed Quick Start Application and start the pro-
cess of programming it into the flash on the 32-bit QE128 microcon-
troller by clicking on the debugger launch button shown here :
From the Connection Manager menu, select “ USB1: DEMOQE”
port and click on “ Connect (Reset).”
From the Loader Warning menu, click on “ OK” to allow the debug-
ger to mass erase the microcontroller’ s on-chip flash memory and
program it with the new application.
Click on the GO button in the debugger to run the application. The
GO button is shown here:
Repeat Step 4 of the Quick Start Guide instructions to observe the
32-bit QE128 device running the same application as the 8-bit
QE128 device did previously.
Figure 3-7: IDE Debugger Launch Button
Figure 3-8: Debugger GO Button
Figure 3-6: MCU Change Wizard
13