HFD3180-103 Finisar Corporation, HFD3180-103 Datasheet - Page 4

• Manufacturer Part Number: HFD3180-103
• Description: Photodetector 5-Pin LC ROSA
• Manufacturer: Finisar Corporation

Specifications of HFD3180-103

• Package: 5LC ROSA
• Rise Time: 0.12 ns

HFD3180-103
NOTES
1.
2.
3.
4.
5.
P R is the average optical power at the fiber face.
P R,OMA is the peak to peak optical power at the fiber face
(Optical Modulation Amplitude)
where ER is the extinction ratio (linear) of the optical
source.
Bandwidth and Low Frequency Cutoff are measured with
a small signal sinusoidal light source with –12dBm
average power
RMS input referred optical noise equivalent power is
obtained by measuring the RMS output noise into a 1875
MHz, 4-pole Bessel-Thompson filter then dividing by the
responsivity. A scaling factor of 14 is used to predict a BER
of 10
Sensitivity is measured with an optical source with an
extinction ratio of 3dB.
P
R
,
OMA
-12
.
≡
2
P
R
ER
(
ER
+
1
2.5GBPS 850NM PIN + PREAMP
−
1
)
6.
7.
8.
9.
10. Group delay is a sensitive measurement to package
11. DJ TIA is specified as contributed DJ by the TIA, obtained
12. RJ TIA is specified as contributed DJ by the TIA, obtained
Stressed receiver sensitivity is measured with 3.5dB
vertical eye closure (intersymbol interference) and with
0.3UI of jitter added. The measurement technique is
defined in IEEE 802.3ae.
Rise/Fall times are corrected for optical source Rise/Fall
times. T
The monitor current slope is measured as the current into
the PDBIAS connection.
interface, and includes the effects of PD, TIA and package.
Measurement is made with TO leads as short as possible.
from
from RJ
Value shown is with no external power supply filtering.
DJ
2
2
TIA
TIA
2
TIA
= RJ
= T
= DJ
2
MEASURED
2
TOTAL
2
TOTAL
- RJ
- DJ
- T
2
OPTICAL
2
2
OPTICAL
OPTICAL