ICS8304AM IDT, Integrated Device Technology Inc, ICS8304AM Datasheet - Page 5

• Manufacturer Part Number: ICS8304AM
• Manufacturer: IDT, Integrated Device Technology Inc

Specifications of ICS8304AM

• Number Of Outputs: 4
• Operating Supply Voltage (max): 3.465V
• Operating Temp Range: 0C to 70C
• Propagation Delay Time: 3.7ns
• Operating Supply Voltage (min): 3.135V
• Mounting: Surface Mount
• Pin Count: 8
• Operating Supply Voltage (typ): 3.3V
• Package Type: SOIC N
• Duty Cycle: 60%
• Operating Temperature Classification: Commercial
• Lead Free Status / RoHS Status: Not Compliant

IDT
The spectral purity in a band at a specific offset from the
fundamental compared to the power of the fundamental is called
the dBc Phase Noise. This value is normally expressed using a
Phase noise plot and is most often the specified plot in many
applications. Phase noise is defined as the ratio of the noise power
present in a 1Hz band at a specified offset from the fundamental
frequency to the power value of the fundamental. This ratio is
expressed in decibels (dBm) or a ratio of the power in the 1Hz
As with most timing specifications, phase noise measurements
has issues. The primary issue relates to the limitations of the
equipment. Often the noise floor of the equipment is higher than
the noise floor of the device. This is illustrated above. The device
ICS8304
LOW SKEW, 1-TO-4 LVCMOS/LVTTL FANOUT BUFFER
™
/ ICS
™
LVCMOS/LVTTL FANOUT BUFFER
A
O
DDITIVE
FFSET
F
ROM
P
HASE
5
C
ARRIER
band to the power in the fundamental. When the required offset
is specified, the phase noise is called a dBc value, which simply
means dBm at a specified offset from the fundamental. By
investigating jitter in the frequency domain, we get a better
understanding of its effects on the desired application over the
entire time record of the signal. It is mathematically possible to
calculate an expected bit error rate given a phase noise plot.
meets the noise floor of what is shown, but can actually be lower.
The phase noise is dependant on the input source and
measurement equipment.
J
ITTER
F
REQUENCY
(12kHz to 20MHz) = 0.173ps typical
(H
Additive Phase Jitter
Z
)
ICS8304AM REV. H OCTOBER 29, 2010
@ 125MHz