111196-4 TE Connectivity, 111196-4 Datasheet - Page 5

• Manufacturer Part Number: 111196-4
• Description: Conn IDC Connector RCP 20 POS 1.27mm IDT RA Cable Mount
• Manufacturer: TE Connectivity
• Type: IDC Connectorr
• Series: AMPMODU System 50r

Specifications of 111196-4

• Pitch: 1.27 mm
• Number Of Rows: 2
• Number Of Contacts: 20
• Gender: RCP
• Contact Plating: Gold Over Nickel
• Termination Method: IDT
• Connector Type: Wire To Board
• Contact Termination: IDC / IDT
• No. Of Contacts: 20
• No. Of Rows: 2
• Pitch Spacing: 1.27mm
• Rohs Compliant: No
• Type Of Connector: Rectangular
• Mating Connector Lock: With
• Wire/cable Type: Ribbon Cable
• Mating Connector Lock Type: Latch
• Voltage (vac): 30
• Insulation Resistance (m?): 5,000
• Contact - Rated Current (a): 0.5
• Solder Tail Contact Plating: Tin-Lead
• Number Of Positions: 20
• Ribbon Cable Centerline Spacing (mm [in]): 0.64 [0.025]
• Latch Material: Stainless Steel
• Contact Base Material: Phosphor Bronze
• Contact Plating, Mating Area, Material: Gold
• Connector Style: Receptacle
• Housing Material: Thermoplastic - GF
• Ul Flammability Rating: UL 94V-0
• Housing Color: Black
• Rohs/elv Compliance: Not ELV/RoHS compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Applies To: Cable
• Temperature Range (°c): -65 – +105

4.3.
4.4.
Rev B
Acceptance
Acceptance is based on verification that the product meets the requirements of Figure 1. Failures
attributed to equipment, test setup or operator deficiencies shall not disqualify the product. If product
failure occurs, corrective action shall be taken and specimens resubmitted for qualification. Testing to
confirm corrective action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan shall specify the sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with the applicable product drawing
and this specification.
NOTE
No straight posted header is required with Paddleboard which solders directly to the
printed circuit board.
Low Level Contact Resistance Measurement Points
Figure 3
108-1109
5 of 6