215570-8 TE Connectivity, 215570-8 Datasheet - Page 93

• Manufacturer Part Number: 215570-8
• Description: Conn IDC Connector M 8 POS 2.54mm IDT RA Cable Mount Reel
• Manufacturer: TE Connectivity
• Type: IDC Connectorr
• Series: Micro-MaTchr

Specifications of 215570-8

• Pitch: 2.54 mm
• Number Of Rows: 2
• Number Of Contacts: 8
• Gender: M
• Contact Plating: Tin Over Nickel
• Termination Method: IDT
• Connector Type: Board To Board
• Contact Material: Phosphor Bronze
• Lead Spacing: 1.27mm
• No. Of Rows: 2
• No. Of Ways: 8
• Termination: RoHS Compliant
• Rohs Compliant: Yes
• Product Type: Connector
• Type Of Connector: Paddleboard Connector
• Mount Angle: Vertical
• Pcb Mount Style: Through Hole
• Insulation Diameter (mm [in]): 0.90 [.035]
• Polarization: With
• Number Of Positions: 8
• Wire Range (mm [awg]): 0.08-0.09² [28]
• Centerline (mm [in]): 1.27 [0.050]
• Contact Base Material: Phosphor Bronze
• Contact Plating, Mating Area, Material: Tin
• Housing Color: Red
• Housing Material: Polyester GF
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Wave solder capable to 240°C, Wave solder capable to 260°C, Wave solder capable to 265°C
• Rohs/elv Compliance History: Always was RoHS compliant
• Applies To: Printed Circuit Board
• Packaging Method: Reel
• Packaging Quantity: 2,500

1. Place pinless header
2. With bottom of pc board
3. Apply an even, centered
over preinstalled posts
so that post tips start
into header cavities.
supported, place steel
block over header. Steel
block must be wider and
longer than header so
that it covers all four sides
of the header. However,
for headers with latches
pre-assembled, the steel
block must not interfere
with the latches.
force on steel block until
header bottoms on pc
board. If posts are
longer than .545 [13.84],
they may be forced
against the steel block
before the header is fully
seated. In this situation,
extreme caution must be
taken so that posts are
not damaged or pushed
out of the pc board.
93