CW7250 ITW Chemtronics, CW7250 Datasheet - Page 2

• Manufacturer Part Number: CW7250
• Description: HEAT SINK GREASE BORON NITRIDE
• Manufacturer: ITW Chemtronics
• Series: CircuitWorks®r
• Type: Greaser

Specifications of CW7250

• Size / Dimension: 3.4 gram Syringe
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

ITW CHEMTRONICS
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
Physical State: White, opaque paste
Odor: None
pH: NA
Vapor Pressure: <0.0001 mmHg
Vapor Density: NA
Boiling Point: >700 F
SECTION 10: STABILITY AND REACTIVITY
Stability: This product is stable.
Incompatibility: Do not mix with amines, strong bases or strong oxidizing agents.
Products of Decomposition: Thermal decomposition at temperatures above 575 0F may release silicon dioxide and carbon dioxide.
Hazardous Polymerization: Not likely to occur.
Conditions to Avoid: Exposure to amines, bases or strong oxidizing agents.
SECTION 11: TOXICOLOGICAL INFORMATION
Inhalation:
NA
NA
Skin:
Boron Nitride
Cancer Information: No ingredients listed as human carcinogens by NTP or IARC
Reproductive effects: none
SECTION 12: ECOLOGICAL INFORMATION
Environmental Impact Information
Avoid runoff into storm sewers and ditches, which lead to waterways. Water runoff can cause environmental damage.
REPORTING
US regulations require reporting spills of this material that could reach any surface waters. The toll-free number for the US Coast Guard National Response Center is:
1-800-424-8802
SECTION 13: DISPOSAL CONSIDERATIONS
Dispose of in accordance with all federal, state and local regulations. Water runoff can cause environmental damage.
SECTION 14: TRANSPORTATION INFORMATION
Air and Ground Shipments:
SECTION 15: REGULATORY INFORMATION
SECTION 313 SUPPLIER NOTIFICATION
This product contains no toxic chemicals subject to the reporting requirements of Section 313 of the Emergency Planning and Community Right-To-Know Act of 1986
(40 CFR 372).
This information should be included on all MSDSs copied and distributed for this material.
TOXIC SUBSTANCES CONTROL ACT (TSCA).
All ingredients of this product are listed on the TSCA Inventory.
WHMIS: Not hazardous. This product has been classified according to the hazard criteria of the CPR and the MSDS contains all of the information required by the
CPR.
SECTION 16: OTHER INFORMATION
Normal ventilation for standard manufacturing practices is usually adequate.
To the best of our knowledge, the information contained herein is accurate. However, all materials may present unknown hazards and should be used with caution. In
particular, improper use of our products and their inappropriate combination with other products and substances may produce harmful results which cannot be
anticipated. Final determination of the suitability of any material is the sole responsibility of the user. Although certain hazards are described herein, we cannot
guarantee that these are the only hazards that may exist.
LD50 Rabbit >20,000 mg/kg
®
Proper Shipping Name
Adhesives, sealants
Not Regulated
Teratogenic effects: none
Ingestion:
Fumed Silica
Boron Nitride
Parafinnic hydrocarbon
Page 2 of 2
Solubility in Water: Negligible
Specific Gravity: 1.50 (Water =1)
Evaporation Rate: < <1
(Butyl acetate=1)
Viscosity: > 1 (water=1)
Mutagenic effects: none
Percent Volatile: <0.5 %
LD50 rat
LD50 rat
LD50 rat
Conditions to Avoid: None
>50,000 mg/kg
> 24,000 mg/kg
3160 mg/kg
MSDS #7250