CDSCB10M7GA119-R0 Murata Electronics North America, CDSCB10M7GA119-R0 Datasheet - Page 49
![FM 10.7MHZ DISCRIM FOR TRF6901/3](/photos/5/97/59713/cdscb_series_sml.jpg)
CDSCB10M7GA119-R0
Manufacturer Part Number
CDSCB10M7GA119-R0
Description
FM 10.7MHZ DISCRIM FOR TRF6901/3
Manufacturer
Murata Electronics North America
Series
CDSCBr
Datasheets
1.CDSCB10M7GA042-R0.pdf
(1 pages)
2.CDSCB10M7GA042-R0.pdf
(1 pages)
3.CDSCB10M7GF123-R0.pdf
(73 pages)
Specifications of CDSCB10M7GA119-R0
Frequency
10.7MHz Center
Bandwidth
500kHz
Filter Type
Discriminator
Insertion Loss
3dB
Package / Case
0.177" L x 0.079" W x 0.039" H (4.50mm x 2.00mm x 1.00mm)
Mounting Type
Surface Mount
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Impedance
-
Other names
490-1240-2
!Note
• This PDF catalog is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our
• This PDF catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
sales representatives or product engineers before ordering.
!Note
1. Do not use this product with bend. The component
2. The component will be damaged when an excessive
3. All kinds of re-flow soldering must not be applied
4. Do not clean or wash the component as it is not
5. Do not use strong acidity flux, more than 0.2wt%
6. In case of covering filter with over coat,
CFULA Series
CFULB Series
CFWLA Series
CFWLB Series
The order quantity should be an integral multiple of the "Minimum Quantity" shown above.
may be damaged if excessive mechanical stress is
applied to it mounted on the printed circuit board.
stress is applied.
on the component.
hermetically sealed.
chlorine content, in flow soldering.
conditions such as material of resin, cure
temperature, and so on should be evaluated
carefully.
Minimum Quantity
Notice (Handling)
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
Part Number
Plastic Case Type CERAFILr Minimum Quantity/Notice
Bulk
200
250
150
150
7. Accurate test circuit values are required to
8. For safety purposes, connect the output of filters
measure electrical characteristics.
It may be a cause of miscorrelation if there is
any deviation, especially stray capacitance, from
the test circuit in the specification.
to the IF amplifier through a D.C. blocking
capacitor. Avoid applying a direct current to the
output of ceramic filters.
Magazine
80
50
55
(pcs.)
47
P05E.pdf
11.1.11
16