MIC2213-AAYML TR Micrel Inc, MIC2213-AAYML TR Datasheet - Page 10

• Manufacturer Part Number: MIC2213-AAYML TR
• Description: Adjustable Sequenced Portable Power IC In 4mm X 4mm MLFT( )
• Manufacturer: Micrel Inc

Specifications of MIC2213-AAYML TR

• Regulator Topology: Positive Adjustable
• Voltage - Output: 1.25 ~ 5.5 V
• Voltage - Input: 2.25 ~ 5.5 V
• Voltage - Dropout (typical): 0.12V @ 150mA, 0.24V @ 300mA
• Number Of Regulators: 2
• Current - Output: 150mA, 300mA
• Current - Limit (min): 150mA, 300mA
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 16-MLF®, QFN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: MIC2213-AAYMLTR; MIC2213-AAYMLTR

Input Capacitor
Good bypassing is recommended from input to ground to
help improve AC performance. A 1µF capacitor or greater
located close to the IC is recommended.
Bypass Capacitor
The internal reference voltage of the MIC2213 can be by-
passed with a capacitor to ground to reduce output noise and
increase power supply rejection (PSRR). A quick-start feature
allows for quick turn-on of the output voltage regardless of
the size of the capacitor. The recommended nominal bypass
capacitor is 0.01µF, but it can be increased without limit.
Output Capacitor
Each regulator output requires a 1µF ceramic output capaci-
tor for stability. The output capacitor value can be increased
to improve transient response, but performance has been
optimized for a 1µF ceramic type output capacitor.
X7R/X5R dielectric-type ceramic capacitors are recom-
mended because of their temperature performance. X7R-type
capacitors change capacitance by 15% over their operating
temperature range and are the most stable type of ceramic
capacitors. Z5U and Y5V dielectric capacitors change value
by as much as 50% and 60% respectively over their operat-
ing temperature ranges. To use a ceramic chip capacitor with
Y5V dielectric, the value must be much higher than a X7R
ceramic capacitor to ensure the same minimum capacitance
over the equivalent operating temperature range.
M9999-101705
10
Adjustable Regulator Design
The MIC2213 allows the programming of the output voltages
1 and 2 anywhere between 1.25V and 5.5V, the maximum
operating rating of the part. Two resistors are required for each
output. Appropriate resistor values are required to prevent
the low quiescent current performance being compromised.
Resistor values recommended are between 100kΩ and
500kΩ.
The resistor values are calculated by:
where V
rately for each output.
R1 = R2
OUT
R1
R2
MIC2213 Adjustable Regulator Design
is the desired output voltage. Calculate sepa-
1.250
V
OUT
VOUT1
ADJ1
– 1
GND
VOUT2
ADJ2
October 2005
R1
R2