MIC33050-GYHL TR Micrel Inc, MIC33050-GYHL TR Datasheet - Page 8

• Manufacturer Part Number: MIC33050-GYHL TR
• Description: High Efficiency 600mA Inductor-less Buck Regulator Featuring Hyper Light Load
• Manufacturer: Micrel Inc
• Type: Step-Down (Buck)r

Specifications of MIC33050-GYHL TR

• Internal Switch(s): Yes
• Synchronous Rectifier: Yes
• Number Of Outputs: 1
• Voltage - Output: 1.8V
• Current - Output: 600mA
• Frequency - Switching: 4MHz
• Voltage - Input: 2.7 ~ 5.5 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 12-MLF®, QFN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Power - Output: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 576-3040-2

Functional Description
VIN
VIN provides power to the MOSFETs for the switch mode
regulator section and to the analog supply circuitry. Due to
the high switching speeds, it is recommended that a 2.2µF
or greater capacitor be placed close to VIN and the power
ground (PGND) pin for bypassing. Refer to the layout
recommendations for details.
EN
The enable pin (EN) controls the on and off state of the
device. A high logic on the enable pin activates the
regulator, while a low logic deactivates it. MIC33050
features built-in soft-start circuitry that reduces in-rush
current and prevents the output voltage from overshooting
at start up. Do not leave floating.
SW
The switch (SW) pin connects directly to the inductor and
provides the switching current necessary to operate in
PWM mode. Due to the high speed switching on this pin,
the switch node should be routed away from sensitive
nodes such as the CFF pin.
OUT
The output pin (OUT) is the output voltage pin following
the internal inductor of the device. Connect an output filter
capacitor equal to 2.2µF or greater to this pin.
SNS
The SNS pin is needed to sense the output voltage at the
output filter capacitor. In order for the control loop to
monitor the output voltage accurately it is good practice to
sense the output voltage at the positive side of the output
filter capacitor where voltage ripple is smallest.
Micrel, Inc.
July 2009
8
CFF
The CFF pin is connected to the SNS pin of MIC33050
with a feed-forward capacitor of 560pF. The CFF pin itself
is compared with the internal reference voltage (V
the device and provides the control path to control the
output. V
noise and should be place away from the SW pin. Refer to
the layout recommendations for details.
PGND
Power ground (PGND) is the ground path for high current.
The current loop for the power ground should be as small
as possible and separate from the Analog ground (AGND)
loop. Refer to the layout recommendations for more
details.
AGND
Signal ground (AGND) is the ground path for the biasing
and control circuitry. The current loop for the signal ground
should be separate from the Power ground (PGND) loop.
Refer to the layout recommendations for more details.
REF
is equal to 0.72V. The CFF pin is sensitive to
M9999-070909-C
MIC33050
REF
) of