S29GL128P10TFI020 Spansion Inc., S29GL128P10TFI020 Datasheet - Page 21
S29GL128P10TFI020
Manufacturer Part Number
S29GL128P10TFI020
Description
IC 128M PAGE-MODE FLASH MEMORY
Manufacturer
Spansion Inc.
Datasheet
1.S29GL128P10TFI020.pdf
(80 pages)
Specifications of S29GL128P10TFI020
Cell Type
NOR
Density
128Mb
Access Time (max)
100ns
Interface Type
Parallel
Boot Type
Not Required
Address Bus
24/23Bit
Operating Supply Voltage (typ)
3/3.3V
Operating Temp Range
-40C to 85C
Package Type
TSOP
Sync/async
Asynchronous
Operating Temperature Classification
Industrial
Operating Supply Voltage (min)
2.7V
Operating Supply Voltage (max)
3.6V
Word Size
8/16Bit
Number Of Words
16M/8M
Supply Current
110mA
Mounting
Surface Mount
Pin Count
56
Lead Free Status / Rohs Status
Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
S29GL128P10TFI020
Manufacturer:
FSC
Quantity:
13
Part Number:
S29GL128P10TFI020
Manufacturer:
SPANSION
Quantity:
20 000
Company:
Part Number:
S29GL128P10TFI020D
Manufacturer:
SPANSION
Quantity:
50 000
7.6
November 17, 2010 S29GL-P_00_A13
Autoselect
The Autoselect mode provides manufacturer ID, Device identification, and sector protection information,
through identifier codes output from the internal register (separate from the memory array) on DQ7-DQ0. This
mode is primarily intended for programming equipment to automatically match a device to be programmed
with its corresponding programming algorithm (see
in-system.
There are two methods to access autoselect codes. One uses the autoselect command, the other applies V
on address pin A9.
When using programming equipment, the autoselect mode requires V
Address pins must be as shown in
To access Autoselect mode without using high voltage on A9, the host system must issue the Autoselect
The Autoselect command sequence may be written to an address within a sector that is either in the read
The Autoselect command may not be written while the device is actively programming or erasing.
The system must write the reset command to return to the read mode (or erase-suspend-read mode if the
It is recommended that A9 apply V
See
When verifying sector protection, the sector address must appear on the appropriate highest order address
command.
or erase-suspend-read mode.
sector was previously in Erase Suspend).
that A9 apply from V
bits (see
been set as required, the programming equipment may then read the corresponding identifier code on
DQ15-DQ0. The Autoselect codes can also be accessed in-system through the command register.
Table 12.1 on page 69
Table 7.4
to
ID
Table
D a t a
to V
S29GL-P MirrorBit
IH
for command sequence details.
7.5). The remaining address bits are don't care. When all necessary bits have
/V
IL
Table
S h e e t
before power-down the V
ID
after power-up sequence is completed. In addition, it is recommended
7.2.
®
Flash Family
Table
7.3). The Autoselect codes can also be accessed
CC
/V
IO
.
ID
(11.5 V to 12.5 V) on address pin A9.
21
ID