LT1719CS6#PBF Linear Technology, LT1719CS6#PBF Datasheet - Page 13

• Manufacturer Part Number: LT1719CS6#PBF
• Manufacturer: Linear Technology

Specifications of LT1719CS6#PBF

• Number Of Elements: 1
• Output Type: Open Collector
• Technology: BiCMOS
• Input Offset Voltage: 2.5@5VmV
• Input Bias Current (typ): 2500(Typ)nA
• Response Time: 1.3ns
• Single Supply Voltage (typ): 3/5V
• Dual Supply Voltage (typ): ±3V
• Supply Current (max): 9mA
• Common Mode Rejection Ratio: 65dB
• Power Supply Rejection Ratio: 80dB
• Power Supply Requirement: Single/Dual
• Single Supply Voltage (min): 2.7V
• Single Supply Voltage (max): 6V
• Dual Supply Voltage (min): ±1.35V
• Dual Supply Voltage (max): ±3V
• Operating Temp Range: 0C to 70C
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 6
• Package Type: TSOT-23
• Lead Free Status / RoHS Status: Compliant

With this in mind, calculation of the resistor values needed
is a two-step process. First, calculate the value of R3 based
on the additional hysteresis desired, the output voltage
swing and the impedance of the primary bias string:
Additional hysteresis is the desired overall hysteresis less
the internal 4mV hysteresis.
The second step is to recalculate R2 to set the same av-
erage threshold as before. The average threshold before
was set at V
calculated based on the average output voltage (+V
and the simplifi ed circuit model in Figure 5. To assure
that the comparator’s noninverting input is, on average,
the same V
APPLICATIONS INFORMATION
R3 = (R1
R2ʹ = (V
REF
TH
⏐⏐
TH
R2)(+V
as before:
– V
= (V
TH
REF
)/(V
S
– 0.6V)/(additional hysteresis)
)(R1)/(R1 + R2). The new R2 is
TH
/R1 + [V
TH
Figure 5. Model for Additional Hysteresis Calculations
– (+V
V
S
REF
)/2]/R3)
R2ʹ
R1
V
TH
S
+
–
/2)
LT1719S8
R3
For additional hysteresis of 10mV or less, it is not un-
common for R2ʹ to be the same as R2 within 1% resistor
tolerances.
This method will work for additional hysteresis of up to a
few hundred millivolts. Beyond that, the impedance of R3 is
low enough to effect the bias string, and adjustment of R1
may also be required. Note that the currents through the
R1/R2 bias string should be many times the input currents
of the LT1719. For 5% accuracy, the current must be at
least 20 times the input current, more for higher accuracy.
This illustration used an LT1719S8; with an LT1719S6 the
same procedure is used with V
V
AVERAGE
1719 F05
=
+V
2
S
+
substituted for +V
LT1719
13
S
.
1719fa