MT48LC32M16A2TG75IT Micron Technology Inc, MT48LC32M16A2TG75IT Datasheet - Page 12
![no-image](/images/manufacturer_photos/0/4/441/micron_technology_inc_sml.jpg)
MT48LC32M16A2TG75IT
Manufacturer Part Number
MT48LC32M16A2TG75IT
Description
Manufacturer
Micron Technology Inc
Type
SDRAMr
Datasheet
1.MT48LC32M16A2TG75IT.pdf
(68 pages)
Specifications of MT48LC32M16A2TG75IT
Organization
32Mx16
Density
512Mb
Address Bus
15b
Access Time (max)
6/5.4ns
Maximum Clock Rate
133MHz
Operating Supply Voltage (typ)
3.3V
Package Type
TSOP-II
Operating Temp Range
-40C to 85C
Operating Supply Voltage (max)
3.6V
Operating Supply Voltage (min)
3V
Supply Current
115mA
Pin Count
54
Mounting
Surface Mount
Operating Temperature Classification
Industrial
Lead Free Status / RoHS Status
Not Compliant
PDF: 09005aef809bf8f3/Source: 09005aef80818a4a
512MbSDRAM.fm - Rev. L 10/07 EN
Note:
10. Issue an AUTO REFRESH command.
11. Wait at least
12. The SDRAM is now ready for mode register programming. Because the mode register
13. Wait at least
7. Wait at least
8. Issue an AUTO REFRESH command.
9. Wait at least
At this point the DRAM is ready for any valid command.
given. All banks will complete their precharge, thereby placing the device in the all
banks idle state.
are allowed.
are allowed.
will power up in an unknown state, it should be loaded with desired bit values prior to
applying any operational command. Using the LMR command, program the mode
register. The mode register is programmed via the MODE REGISTER SET command
with BA1 = 0, BA0 = 0 and retains the stored information until it is programmed again
or the device loses power. Not programming the mode register upon initialization will
result in default settings which may not be desired. Outputs are guaranteed High-Z
after the LMR command is issued. Outputs should be High-Z already before the LMR
command is issued.
allowed.
If desired, more than two AUTO REFRESH commands can be issued in the sequence.
After steps 9 and 10 are complete, repeat them until the desired number of AUTO
REFRESH +
t
t
t
t
t
RFC loops is achieved.
RP time; during this time, NOPs or DESELECT commands must be
RFC time, during which only NOPs or COMMAND INHIBIT commands
RFC time, during which only NOPs or COMMAND INHIBIT commands
MRD time, during which only NOP or DESELECT commands are
12
Micron Technology, Inc., reserves the right to change products or specifications without notice.
512Mb: x4, x8, x16 SDRAM
Functional Description
©2000 Micron Technology, Inc. All rights reserved.