VV6411C036 STMicroelectronics, VV6411C036 Datasheet - Page 25
![no-image](/images/manufacturer_photos/0/6/637/stmicroelectronics_sml.jpg)
VV6411C036
Manufacturer Part Number
VV6411C036
Description
Manufacturer
STMicroelectronics
Type
CMOSr
Datasheet
1.VV6411C036.pdf
(63 pages)
Specifications of VV6411C036
Sensor Image Color Type
Color
Sensor Image Size Range
30,720 to 250,920Pixels
Operating Supply Voltage (typ)
3.3V
Operating Temp Range
0C to 40C
Package Type
CLCC
Operating Temperature Classification
Commercial
Mounting
Surface Mount
Pin Count
36
Lead Free Status / RoHS Status
Supplier Unconfirmed
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
STV0680B + VV6444/6410/6500
4.9.5
4.9.6
4.10
4.11
With STV0680B-003, these pins are used, as detailed in
Their specific functions are detailed in the reference design and in the following documents
available from ST:
Audio record hardware interface (STV0680B-003 only)
The firmware implements a successive approximation A/D conversion by outputting successive
analogue levels through the DAC output, which are compared with the actual signal level (output
from the sensor microphone preamplifier), and the resultant high or low signal from the comparator
is read at GPIO4. The sampling frequency is 11kHz, and the successive approximation is done at 8
bits resolution per sample. It is not possible to speed up the sampling frequency due to the limitation
of STV0680B firmware speed.
An actual hardware implementation is given in the audio application note AN1310.
Audio playback hardware interface (STV0680B-003 only)
The firmware outputs the desired signal level through the DAC output, which is amplified to the
speaker or headphone socket. GPIO6 is used to switch off the amplifier during periods of audio
recording, to prevent the successive approximation waveform from being heard during periods of
recording, and to reduce the power consumption and unwanted crackle through the speaker.
An actual hardware implementation is given in the audio application note AN1310.
Flashgun hardware interface (STV0680B-003 only)
STV0680B-003 will revert to flashgun exposure when it detects GPIO2 is high. Ideally the hardware
should combine the two factors of (a) user intention (e.g. user switches on flashgun) and (b) charge
sensing (i.e. flash is charged up and ready to fire).
These two factors (a) and (b) are independent, since there may be a delay of several seconds
between switching on the flashgun charger, and the flashgun being able to fire. To revert to flashgun
exposure before the flashgun is completely charged up would cause very bad pictures to be taken
in low light conditions because there is no “low light” threshold when flashgun exposure is enabled,
since the camera expects a flash to fire. A suggested flashgun hardware interface is given in the
flashgun application note AN1312.
When flashgun exposure is enabled and the shutter button is pressed, a picture will be taken and
the flash trigger pin GPIO7 will be pulsed low at the correct point in time so that all lines of the
CMOS imager are exposed.
IR filter
An Infra-Red Blocking Filter is required to achieve correct colour response. The exact specification
for the IR filter characteristics are given in the reference design manual.
Audio Record
Audio
Playback
Flashgun
Audio: Application note AN1310
Flashgun: Application note AN1312
GPIO
Yes
No
No
2
Table 6 : Other GPIO usage with STV0680-003
Version 3.4
Yes
No
No
4
Table 6
STV0680B hardware interfaces
Yes
.
No
No
6
Yes
No
No
7
25/63