UM9608 MICROSEMI, UM9608 Datasheet - Page 11
![no-image](/images/manufacturer_photos/0/4/443/microsemi_sml.jpg)
UM9608
Manufacturer Part Number
UM9608
Description
Manufacturer
MICROSEMI
Type
Switchr
Datasheet
1.UM9608.pdf
(16 pages)
Specifications of UM9608
Configuration
Single
Power Dissipation
500mW
Operating Temperature Classification
Military
Reverse Voltage
400V
Operating Temperature (min)
-65C
Pin Count
2
Applications Frequency Range
UHF/SHF
Lead Free Status / RoHS Status
Not Compliant
Installation in Microstrip
UM9606 is designed to be affixed to the ground plane surface
of a microstrip board. The UM9603, UM9604, UM9607, and
UM9608 were designed to be affixed to a backing plate as
shown. It was experimentally determined that at frequencies
greater than 2 GHz the anode of the diode should be
approximately 0.010” (.254mm) above the top surface of the
microstrip for lowest insertion loss.
Figure: UM9601/UM9602 Microstrip Mount
Design Example – 900 MHz Antenna Switch
diode is a quarter-wave antenna switch covering the frequency
of 800-900 MHz. The circuit design for this switch is shown
and was constructed using 0.025” (0.645mm) alumina
microstrip.
The cup type flange on the UM9601, UM9602, UM9605, and
An example of a practical circuit design using a UM9601
Copyright 2005
Rev. 0, 2006-01-17
28
26
24
22
20
18
16
14
12
10
8
6
10
0.025" (0.635mm) ALUMINA MICROSTRIP SPST SWITCH
ISOLATION vs FREQUENCY AND DIODE CURRENT
Microsemi
DIODE CURRENT (mA)
TYPICAL
FOR MICROSTRIP 900 MHz ANTENNNA SWITCHES
100
mounted diode. The UM9601 was selected for shunt mounted
device (SPST performance at 1 GHz: 0.2dB insertion loss and
25dB isolation) and because it is the lowest cost diode in the
UM9601-UM9608 series. A UM9401 axial lead diode was
chosen for the series mounted device.
and in the following table. It should be noted that the loss
values are actual measured numbers including losses due to the
capacitors, bias networks, connectors, as well as the board. In a
typical radio application where the antenna switch circuit board
is integrated in the same microstrip board that contains
transmitter and receiver elements the connector loss is
eliminated. This will result in lower overall insertion loss values
than indicated here.
melting temperature (up to 300
diode. Conductive epoxy may also be employed. The thermal
resistance of solder mounted UM9601-UM9604 in their test
boards was less than 20
thermal resistance was less than 30
For solder adhesion the microstrip may be heated to solder
C
This antenna switch uses a series mounted diode and a shunt
The performance of this switch is displayed in the graphs
AND MICROWAVE APPLICATIONS
O S
1 GHz
3 GHz
UM9601 - UM9604
UM9605 - UM9608
UM9605 - UM9608
UM9601 - UM9604
UM9601 – UM9608
O
S
o
C/W; for the UM9605-UM9608
1000
o
C) with no damage to the
o
C/W.
Page 11