GLK12232-25-WB-V Matrix Orbital, GLK12232-25-WB-V Datasheet - Page 17
![no-image](/images/no-image-200.jpg)
GLK12232-25-WB-V
Manufacturer Part Number
GLK12232-25-WB-V
Description
LCD GRAPHIC DISPL 122X32 WHT BLU
Manufacturer
Matrix Orbital
Series
-r
Datasheet
1.GLK12232-25-WBL-E.pdf
(39 pages)
Specifications of GLK12232-25-WB-V
Display Type
LCD - Color
Display Mode
Transmissive
Viewing Area
76.00mm L x 25.20mm W
Backlight
LED - White
Dot Size
0.52mm W x 0.62mm H
Dot Pitch
0.53mm x 0.53mm
Dot Pixels
122 x 32
Interface
I²C, RS232, TTL
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
GLK12232-25-WBL-V
4.2.7 Initialize bar graph (254 103 [ref][type][x1][y1][x2][y2])
from (x1,y1) (top left) to (x2,y2) (bottom right). A maximum of 16 bar graphs with reference numbers from
0 to 15 can be initialized as;
The bar graphs may be located anywhere on the display, but if they overlap, they will not display properly.
This command doesn’t actually draw the graph, it must be ’filled in’ using the “Write to bar graph” com-
mand, described below. The unit saves time by only drawing that part of the bar graph which has changed
from the last write, so the representation on the screen may not survive a screen clear or other corruptive
action. A write of value zero, followed by new values will restore the proper look of the bar graph.
4.2.8 Write to bar graph (254 105 [reference number][value])
bar graph [reference number] to value [value]. [value] is given in pixels and should not exceed the available
height / width of the graph. (If it does, the graph will simply be written to its maximum size.)
4.2.9 Display saved bitmap (254 98 [reference number][x][y])
the screen at pixel location (x, y) where this location defines the top left corner of the bitmap. Bitmaps and
fonts may use the same reference numbers, for example it is possible to have both a bitmap 1 and a font 1.
4.3 Flow Control
placement. Flow control is enabled or disabled by two commands. If flow control is enabled, the display
will return an "almost full" message (0xFE) to the micro-controller when its internal buffer fills to a defined
level, and an "almost empty" message (0xFF) when the buffer contents drop to a defined level.
Matrix Orbital
This command initializes a bar graph referred to by number [reference number] of type [type] with size
• [type = 0] Vertical, bottom referenced
• [type = 1] Horizontal left referenced
• [type = 2] Vertical top referenced
• [type = 3] Horizontal right referenced
Once the bar graph has been initialized it can be ’filled in’ using this command. This command sets the
This command causes a previously stored bitmap referenced by [reference number] to be displayed to
The display has built in flow control which is very useful during direct bitmap display and multiple pixel
NOTE It is important that [x1] is less than [x2], and [y1] is less than [y2].
NOTE
mogd.exe.
The reference number is established when the bitmap is saved, normally using
GLK12232-25-WBL
13