LK202-25-FW-E Matrix Orbital, LK202-25-FW-E Datasheet - Page 14
![no-image](/images/no-image-200.jpg)
LK202-25-FW-E
Manufacturer Part Number
LK202-25-FW-E
Description
LCD CHAR DISP 20X2 I2C/RS232/TTL
Manufacturer
Matrix Orbital
Series
LK202-25r
Datasheet
1.LK202-25-GW.pdf
(63 pages)
Specifications of LK202-25-FW-E
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
2.2 Power/Data Connector
25 requires five volts for the standard display module, between nine to fifteen for the wide voltage (V)
and between nine to thirty-five volts for the wide voltage with efficient power supply module (VPT). The
voltage is applied through pins one and four of the four pin Power/Data connector. Pins two and three are
reserved for serial transmission, using either the RS-232/TTL or the I
been selected by the Protocol Select Jumpers. Pins two and three may be reversed by changing the Legacy
Connector Jumpers in order to be compatible with previous PCB revisions.
2.3 Protocol Select Jumpers
display module between RS-232, TTL and I
with solder jumps on the 232 jumpers. In order to place the display module in I
remove the solder jumps from the 232 jumpers and then place them on the I2C jumpers. The display will
now be in I
to change the display to TTL mode, simply remove the zero ohm resistors from the 232 or I
solder them to the TTL jumpers.
Matrix Orbital
The Power/Data Connector provides a standard connector for powering the display module. The LK202-
The Protocol Select Jumpers, pictured below in
2
C mode and have a default slave address of 0x50 unless it has been changed. Similarly, in order
Supply Current
Supply Voltage
WARNINGS
Inrush
• Do not apply any power with reversed polarization.
• Do not apply any voltage other than the specified voltage.
Figure 16: Power Connector and Pin out
Table 1: Power Requirements
+5Vdc ±0.25V
Standard
2
C protocols. As a default, the jumpers are set to RS-232 mode
LK202-25
Pin
Pin
Pin
Pin
figure 17
1
2
3
4
148 mA typical
+9V to +15V
148 mA
PWR
Rx \ SCL (I
Tx \ SDA (I
GND
, provide the means necessary to toggle the
-V
(See table 1)
2
C protocol, depending on what has
2
2
C clock)
C data)
+9V to +35V
-VPT
2
C mode you must first
2
C jumpers and
10