ICS9179BF-01T IDT, Integrated Device Technology Inc, ICS9179BF-01T Datasheet - Page 4

• Manufacturer Part Number: ICS9179BF-01T
• Description: IC CLOCK BUFFER SDRAM 48-SSOP
• Manufacturer: IDT, Integrated Device Technology Inc
• Type: Fanout Buffer (Distribution)r

Specifications of ICS9179BF-01T

• Number Of Circuits: 1
• Ratio - Input:output: 1:18
• Differential - Input:output: No/No
• Input: Clock
• Output: Clock
• Frequency - Max: 150MHz
• Voltage - Supply: 3.135 V ~ 3.465 V
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 48-SSOP
• Frequency-max: 150MHz
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 9179BF-01T

ICS9179B-01
General I
A.
B.
C.
D.
E.
F.
G.
H.
Serial Configuration Command Bitmaps
Byte 0: SDRAM Clock Register
Notes: 1 = Enabled; 0 = Disabled, outputs held low
For the clock generator to be addressed by an I
sequence, with an acknowledge bit between each byte.
The clock generator is a slave/receiver I
in the latches for verification. (set R/W# to 1 above). There is no BYTE count supported, so it does not meet
the Intel SMB PIIX4 protocol.
The data transfer rate supported by this clock generator is 100K bits/sec (standard mode)
The input is operating at 3.3V logic levels.
The data byte format is 8 bit bytes.
To simplify the clock generator I
bytes must be accessed in sequential order from lowest to highest byte with the ability to stop after any complete
byte has been transferred. The Command code and Byte count shown above must be sent, but the data is ignored
for those two bytes. The data is loaded until a Stop sequence is issued.
maintain all prior programming information.
At power-on, all registers are set to a default condition. Bytes 0 through 2 default to a 1 (Enabled output state).
In the power down mode (PWR_DWN# Low), the SDATA and SCLK pins are tristated and the internal data latches
2
C serial interface information
2
C interface, the protocol is set to use only block writes from the controller. The
2
C component. It can "read back "(in Philips I
Note: PWD = Power-Up Default
2
C controller, the following address must be sent as a start
4
Byte 0, 1, 2, etc in sequence until STOP.
Then Byte 0, 1, 2, etc in
sequence until STOP.
2
C protocol) the data stored