1-487545-4 TE Connectivity, 1-487545-4 Datasheet - Page 5

• Manufacturer Part Number: 1-487545-4
• Description: 017 HOUSING FFC RCPT 050CL SR
• Manufacturer: TE Connectivity

Specifications of 1-487545-4

• Rohs Compliant: YES
• Type Of Connector: Rectangular
• Connector Type: Housing
• Mating Connector Lock: With
• Insertion Force: Normal
• Loaded With Mtf Contacts: No
• Wire/cable Type: FFC
• Mating Connector Lock Type: Latch
• Flame Retardant: Yes
• Insulation Resistance (m?): 5,000
• Dielectric Withstanding Voltage (v): 300
• Number Of Positions: 17
• Number Of Rows: Single
• Connector Style: Receptacle
• Housing Material: Polyester
• Ul Flammability Rating: UL 94V-0
• Housing Color: Black
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant
• Applies To: Cable
• Temperature Range (°c): -55 – +105

4.
4.1.
4.2.
4.3.
4.4.
Rev B
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form, fit or function are made to product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of original testing
sequence as determined by development/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that product meets requirements of Figure 1. Failures attributed to
equipment, test setup or operator deficiencies shall not disqualify product. When product failure occurs,
corrective action shall be taken and samples resubmitted for qualification. Testing to confirm corrective
action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan will specify sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with applicable product drawing and
this specification.
Sample Selection
Samples shall be prepared in accordance with applicable Instruction Sheets and shall be selected
at random from current production. Test groups 1, 2, 3, 4 and 5 shall each consist of a minimum of
3 cable assemblies with a minimum of 10 contacts of each plating type per cable assembly. Mating
contact circuits in each cable assembly shall be randomly selected and identified. Unless otherwise
specified, these contacts shall be used for all measurements required in these test groups. Test
group 6 shall consist of 6 unterminated solder tabs.
Test Sequence
Qualification inspection shall be verified by testing samples as specified in Figure 2.
108-16022
5 of 6