1-5111595-7 TE Connectivity, 1-5111595-7 Datasheet - Page 2

• Manufacturer Part Number: 1-5111595-7
• Description: 046 ASSY SYS 50 PADDLEBOARD
• Manufacturer: TE Connectivity

Specifications of 1-5111595-7

• Type Of Connector: Paddleboard
• Connector Type: Connector Assembly
• Mating Connector Lock: Without
• Wire/cable Type: Ribbon Cable
• Mount Angle: Vertical
• Pcb Mount Retention: Without
• Cover Material: Polyester
• Voltage (vac): 30
• Insulation Resistance (m?): 5,000
• Contact - Rated Current (a): 0.5
• Termination Post Length (mm [in]): 2.54 [0.100]
• Number Of Positions: 46
• Ribbon Cable Centerline Spacing (mm [in]): 0.64 [0.025]
• Contact Termination Type: Through Hole
• Contact Base Material: Copper Alloy
• Contact Plating, Mating Area, Material: Tin
• Housing Material: Liquid Crystal Polymer (LCP)
• Ul Flammability Rating: UL 94V-0
• Housing Color: Black
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Wave solder capable to 240°C, Wave solder capable to 260°C, Wave solder capable to 265°C
• Rohs/elv Compliance History: Always was RoHS compliant
• Applies To: Printed Circuit Board
• Temperature Range (°c): -65 – +105

3.2.
3.3.
3.4.
3.5.
Rev B
Initial examination of product.
Final examination of product.
Low level contact resistance.
Insulation resistance.
Withstanding voltage.
Vibration, sinusoidal.
Materials
Materials used in the construction of this product shall be as specified on the applicable product
drawing.
Ratings
!
!
!
Performance and Test Description
Product is designed to meet the electrical, mechanical and environmental performance requirements
specified in Figure 1. Unless otherwise specified, all tests shall be performed at ambient environmental
conditions per EIA-364.
Test Requirements and Procedures Summary
Test Description
Voltage: 30 volts AC
Current: Signal application only, 0.5 ampere maximum per single circuit
Temperature: -65 to 105° C
Meets requirements of product
drawing.
Meets visual requirements.
30 milliohms maximum.
5000 megohms minimum.
1 minute hold with no breakdown or
flashover.
No discontinuities of 1 microsecond
or longer duration.
See Note.
Figure 1 (continued)
MECHANICAL
ELECTRICAL
Requirement
EIA-364-18.
Visual and dimensional (C of C)
inspection per product drawing.
EIA-364-18.
Visual inspection.
EIA-364-23.
Subject specimens to 100
milliamperes maximum and 20
millivolts maximum open circuit
voltage.
See Figure 3.
EIA-364-21.
Test between adjacent contacts of
unmated and unterminated
contacts within a row.
EIA-364-20,
Condition I.
200 volts AC at sea level.
Test between adjacent contacts of
unterminated specimens.
EIA-364-28,
Test Condition III.
Subject mated specimens to 10-
2000-10 Hz traversed in 15 minutes
with 1.5 mm [.06 in] maximum total
excursion. 4 hours in each of 3
mutually perpendicular planes.
See Figure 4.
Procedure
108-1109
2 of 6