1734595-3 TE Connectivity, 1734595-3 Datasheet - Page 3

• Manufacturer Part Number: 1734595-3
• Description: 1.0 WTB SR VT HDR 3 POS
• Manufacturer: TE Connectivity

Specifications of 1734595-3

• Product Type: Connector
• Connector Type: Header
• Mount Angle: Vertical
• Number Of Positions: 3
• Centerline (mm [in]): 1.00 [0.039]
• Number Of Rows: Single
• Locking Interface: Without
• Contact Type: Pin
• Contact Termination Type: Surface Mount
• Contact Base Material: Phosphor Bronze
• Contact Finish: Matte Tin over Nickel
• Connector Style: Plug
• Housing Color: Natural
• Ul Flammability Rating: UL 94V-0
• Housing Material: High Temperature Thermoplastic
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Reflow solder capable to 245°C, Reflow solder capable to 260°C
• Rohs/elv Compliance History: Always was RoHS compliant
• Packaging Quantity: 1,000/Reel

Rev
Item
NOTE
13
14
15 Salt Spray
16
17 Insertion force
18 Withdraw force
19 Cramp retention force
20 Current Rating
D
Thermal Shock
Humidity-Temperature
Cycle
Resistance to Reflow
Soldering Heat
Shall meet visual requirements, show no physical damage, and meet requirements of additional
tests as specified in the Product Qualification and Requalification Test Sequence shown in
Figure 2.
Description
No Damage
No Damage
No Damage
No physical damage shall occur.
Lead-free type
No physical damage shall occur.
Insertion: 1.47 N (0.15 kgf) Max.
Withdraw: 5.88 N (0.6 kgf) Min.
9.8 N (1.0 kgf) Min.
30℃ max. under loaded rating
current for 1 Amp
Environmental Requirements
Requirement
Figure 1 (end)
Mated Connector
-55+/-3℃ (30 minutes),
+105+/-2℃ (30 minutes)
Making this a cycle, repeat 5 cycles
Mated Connector
25 – 65℃, 95% RH, 10 Cycles
(See Fig. 2)
Subject mated connectors to 35+/-2℃ and
5+/-1% salt condition for 48 hours. After
test, rinse the sample with water and
recondition the room temperature for 1
hour.
Pre Heat: 100 – 150°C, 60 to sec Min.
Heat: 210°C, 30 sec. Min.
Peak Temp.: 235°C
Pre-soak condition, 40°C / 95﹪R.H. for 48
hours.
Pre Heat: 150 ~ 180°C, 90±30 sec.
Heat: 220°C Min., 30±10 sec.
Peak Temp.: 260 +0/-5°C.
Duration: 2 cycles
Operation Speed: 10 mm/min.
Measure the force required for terminal to
insert housing
Operation Speed: 10 mm/min.
Measure the force required for terminal to
withdraw housing
Operation Speed: 10 mm/min.
Measure the force required to lock the
terminal on device and then pull the wire
cable by load cell
Apply test current of loaded rating current
to the wire gauge (UL1571 AWG #28),
and measure the temperature rising, after
the temperature becomes stabilized
deduct ambient temperature from the
measured value
Procedure
108-57264
3 of 4