211159-1 TE Connectivity, 211159-1 Datasheet - Page 3
![PIN CONTACT ASSY](/photos/41/58/415858/pre4o5017a_sml.jpg)
211159-1
Manufacturer Part Number
211159-1
Description
PIN CONTACT ASSY
Manufacturer
TE Connectivity
Specifications of 211159-1
Rohs Compliant
YES
Product Type
Contact
Product Series
109
Termination Method To Wire/cable
Crimp
High Current
No
Wire Range (mm [awg])
8.00² [8]
Retention Clip Material
Phosphor-Bronze
Contact Type
Pin
Contact Size
8
Contact Style
Power
Contact Plating, Mating Area, Material
Gold (50)
Density
Standard
Government/industry Qualification
No
Rohs/elv Compliance
RoHS compliant, ELV compliant
Lead Free Solder Processes
Not relevant for lead free process
Rohs/elv Compliance History
Always was RoHS compliant
Nasa Qualification
No
Applies To
Wire/Cable
Packaging Method
Loose Piece
Rev B
Physical shock.
Durability.
Contact retention.
Mating force.
Unm ating force.
Therm al shock.
Hum idity-tem perature cycling.
Tem perature life.
Mixed flowing gas.
NOTE
Test Description
Shall meet visual requirements, show no physical damage and shall meet requirements of
additional tests as specified in Test Sequence in Figure 2.
No discontinuities of 1 m icrosecond
or longer duration.
See Note.
See Note.
Contacts shall not dislodge.
80 ounces m axim um initial per
contact.
5 ounces m inim um initial per
contact.
See Note.
See Note.
See Note.
See Note.
ENVIRONMENTAL
Figure 1 (end)
Requirem ent
TE Spec 109-30.
TE Spec 109-26-4,
except 300 G's and 3 m illiseconds.
Subject m ated sam ples to 300 G's
half-sine shock pulses of 3
m illiseconds duration. 3 shocks in
each direction applied along 3
m utually perpendicular planes, 18
total shocks.
TE Spec 109-27.
Mate and unm ate sam ples for 500
cycles at m axim um rate of 300
cycles per hour.
Apply axial load of 15 pounds to
contacts and hold for 5 seconds.
TE Spec 109-42, Condition A.
Measure force necessary to m ate
sam ples at m axim um rate of .5 inch
per m inute.
TE Spec 109-42, Condition A.
Measure force necessary to
unm ate sam ples at m axim um rate
of .5 inch per m inute.
TE Spec 109-22.
Subject m ated sam ples to 5 cycles
between -55 and 125°C.
TE Spec 109-23-3,
Condition B.
Subject m ated sam ples to 10
cycles between 25 and 65°C at
95% RH.
TE Spec 109-43.
Subject m ated sam ples to
tem perature life at 125°C for 1000
hours.
TE Spec 109-85-2.
Subject m ated sam ples to
environm ental class II for 14 days.
Procedure
108-10045
3 of 6