322-HCS-5P2-424 TE Connectivity, 322-HCS-5P2-424 Datasheet - Page 3

• Manufacturer Part Number: 322-HCS-5P2-424
• Description: 322-HCS-5P2-424=ASSY. HOLTITE
• Manufacturer: TE Connectivity

Specifications of 322-HCS-5P2-424

• Socket Style: Standard
• Profile: Zero
• Frame Style: Film Carrier
• Leg Style: Straight
• Proprietary Name: HOLTITE
• Contact Resistance (m?): 10
• Contact Rating: 3A
• Termination Post Length (mm [in]): 3.18 [0.125]
• Height Above Pc Board (mm [in]): 0.00 [0.000]
• Centerline (mm [in]): 2.54 [0.100]
• Row-to-row Spacing (mm [in]): 10.16 [0.400]
• Number Of Positions: 24
• Mount Style: Vertical
• Contact Termination Type: Through Hole
• Contact Base Material: Beryllium Copper
• Contact Plating, Mating Area, Material: Gold (25)
• Contact Style: Screw Machine
• Mating Contact Type: Four-Fingered
• Number Of Patterns Per Reel: 208
• Carrier Strip Material: Mylar
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant
• Temperature Range (°c): 125
• Packaging Method: Reel
• Packaging Quantity: 5,000

Rev B
Insertion force.
Withdrawal force.
Contact retention.
Thermal shock.
Humidity-temperature cycling.
Salt spray.
Temperature cycling.
NOTE
Test Description
Shall meet visual requirements, show no physical damage, and meet requirements of additional
tests as specified in the Product Qualification and Requalification Test Sequence shown in Figure
2.
330 grams maximum.
16 grams minimum.
2,267 grams minimum.
See Note.
See Note.
See Note.
See Note.
ENVIRONMENTAL
Figure 1 (end)
Requirement
EIA-364-13.
Measure the force necessary to
insert a .020 inch diameter polished
steel test pin at a maximum rate of
12.7 mm [.5 in] per minute.
EIA-364-13.
Measure force necessary to
withdraw a .016 inch diameter
polished steel test pin at a
maximum rate of 12.7 mm [.5 in]
per minute.
EIA-364-13.
Measure force necessary to push a
contact out of an .039 inch diameter
plated through hole.
EIA-364-32, Test Condition IV.
Subject specimens to 5 cycles
between -65 and 150° C.
EIA-364-31, Method III.
Subject specimens to 10 cycles (10
days) between 25 and 65° C at 80 to
100% RH.
EIA-364-26, Test Condition B.
Subject specimens to a 5% salt fog
mist for 48 hours.
EIA-364-32, Test Condition VII.
Except: Subject specimens to 100
cycles between -40 and 120° C,
dwell time and transition time shall
be 30 minutes (120 minute cycle).
Procedure
108-1979
3 of 5