MCP3553-E/MS Microchip Technology, MCP3553-E/MS Datasheet - Page 16
![IC ADC 22BIT 2.7V 1CH SPI 8MSOP](/photos/6/59/65932/mfg_150_c04-111_ms_8-msop_sml.jpg)
MCP3553-E/MS
Manufacturer Part Number
MCP3553-E/MS
Description
IC ADC 22BIT 2.7V 1CH SPI 8MSOP
Manufacturer
Microchip Technology
Specifications of MCP3553-E/MS
Package / Case
8-TSSOP, 8-MSOP (0.118", 3.00mm Width)
Number Of Bits
22
Sampling Rate (per Second)
60
Data Interface
Serial, SPI™
Number Of Converters
1
Voltage Supply Source
Single Supply
Operating Temperature
-40°C ~ 125°C
Mounting Type
Surface Mount
Architecture
Delta-Sigma
Conversion Rate
0.06 KSPs
Input Type
Voltage
Maximum Operating Temperature
+ 85 C
Mounting Style
SMD/SMT
Minimum Operating Temperature
- 40 C
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
For Use With
MCP355XDV-MS1 - BOARD DEV SENSOR APP MCP355XMCP355XDM-TAS - BOARD DEMO TINY APP SNSR MCP355X
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
MCP3550/1/3
Once a power-up event has occurred, the device must
require additional time before a conversion can take
place. During this time, all internal analog circuitry must
settle before the first conversion can occur. An internal
timer counts 32 internal clock periods before the
internal oscillator can provide clock to the conversion
process. This allows all internal analog circuitry to
settle to their proper operating point. This timing is
typically less than 300 µs, which is negligible compared
to one conversion time (e.g. 72.7 ms for the
MCP3551). Figure 4-6 illustrates the conditions for a
power-up and power-down event under typical start-up
conditions.
FIGURE 4-6:
4.7
When not internally converting, the two modes of
operation for the MCP3550/1/3 devices are the
Shutdown and Sleep modes. During Shutdown mode,
all internal analog circuitry, including the POR, is turned
off and the device consumes less than 1 µA. When
exiting Shutdown mode, the device must require addi-
tional time before a conversion can take place. During
this time, all internal analog circuitry must settle before
the first conversion can occur. An internal timer counts
32 internal clock periods before the internal oscillator
can provide clock to the conversion process. This
allows all internal analog circuitry to settle to their
proper operating point. This timing is typically less than
300 µs, which is negligible compared to one conversion
time (72.7 ms for MCP3551).
DS21950D-page 16
V
2.2V
2.0V
DD
0V
Shutdown Mode
Reset
Start-up
300 µs
Power-On Reset Operation.
Operation
Normal
Reset
Time
4.8
During Sleep mode, the device is not converting and is
awaiting data retrieval; the internal analog circuitry is
still running and the device typically consumes 10 µA.
In order to restart a conversion while in Sleep mode,
toggling CS to a logic-high (placing the part in Shut-
down mode) and then back to a logic-low will restart the
conversion. Sleep can only be entered in Single
Conversion mode. Once a conversion is complete in
Single Conversion mode, the device automatically
enters Sleep mode.
Sleep Mode
© 2007 Microchip Technology Inc.