487940-4 TE Connectivity, 487940-4 Datasheet - Page 2

• Manufacturer Part Number: 487940-4
• Description: FFC,SLDR TAB CONTACT,.050" CNT
• Manufacturer: TE Connectivity

Specifications of 487940-4

• Rohs Compliant: YES
• Product Type: Contact
• Termination Method To Wire/cable: Solder Tab
• Wire/cable Type: FFC
• Solder Tail Contact Plating: Gold Flash
• Centerline (mm [in]): 1.27 [0.050]
• Contact Type: Pin
• Contact Plating, Mating Area, Material: Matte Tin
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Reflow solder capable to 245°C, Reflow solder capable to 260°C
• Rohs/elv Compliance History: Always was RoHS compliant
• Packaging Method: Strip

|
|
|
|
3.5.
Examination of product.
Termination resistance.
Insulation resistance.
Dielectric withstanding voltage.
Solderability.
Vibration, sinusoidal.
Physical shock.
Durability.
Contact retention in housing.
Mating force.
Rev B
Test Requirements and Procedures Summary
Test Description
Meets requirements of product
drawing and Application
Specification 114-16008.
25 milliohms maximum.
5000 megohms minimum initial.
1000 megohms minimum final.
300 volts AC at sea level.
Solderable area shall have
minimum of 95% solder coverage.
No discontinuities of 1 microsecond
or longer duration.
See Note.
No discontinuities of 1 microsecond
or longer duration.
See Note.
See Note.
2 pounds minimum per contact.
No damage to contacts.
8 ounces maximum per contact.
Figure 1 (continued)
MECHANICAL
ELECTRICAL
Requirement
Visual, dimensional and functional
per applicable quality inspection
plan.
TE Spec 109-6-1.
Subject mated contacts assembled
in housing to 50 mv maximum open
circuit at 100 ma maximum.
See Figure 3.
TE Spec 109-28-6.
Test between adjacent contacts of
mated connector assemblies at 250
volts DC maximum.
TE Spec 109-29-1.
Test between adjacent contacts of
mated connector assemblies.
TE Spec 109-11-1.
Subject contacts to solderability.
TE Spec 109-21-3.
Subject mated connectors to 15 G's
between 10-2000-10 Hz traversed
in 20 minutes. Four hours in each of
3 mutually perpendicular planes.
See Figure 4.
TE Spec 109-26-9.
Subject mated connectors to 100
G's sawtooth shock pulses of 6
milliseconds duration. Three shocks
in each direction applied along 3
mutually perpendicular planes, 18
total shocks.
See Figure 4.
TE Spec 109-27.
Mate and unmate connector
assemblies for 100 cycles for 30
µinch gold plating at maximum rate
of 150 cycles per hour.
TE Spec 109-30, except grip cable.
Apply axial load to contacts.
TE Spec 109-42, Condition A.
Measure force necessary to mate
connector assemblies a distance of
.280 inch from point of initial contact
at maximum rate of .5 inch per
minute.
Procedure
108-16022
2 of 6