804-1260 XANTREX TECHNOLOGY, 804-1260 Datasheet - Page 41

• Manufacturer Part Number: 804-1260
• Description: 60A-12V TRUECHARGE 2 SERIES BATTERIE CHARGER XANTREX
• Manufacturer: XANTREX TECHNOLOGY

Specifications of 804-1260

• Battery Charger Type: Switch Mode
• Battery Technologies Supported: Lead Acid
• Supply Voltage: 265VAC
• Charge Current Max: 60A

975-0402-01-01
This guide for use by qualified installers only
WARNING: Shock hazard
The rubber boots must be installed over the Truecharge™ 2 Battery
Charger DC terminals to keep water off of live parts and to
maintain the chargers' IP-32 and drip-proof ratings.
5. Insert and slide the rubber boot(s) over the charger end of
6. Install crimp lugs on the charger end of the DC battery
CAUTION: Reverse polarity damage
Before proceeding to the next step, carefully check the wiring
polarity – make sure the positive terminals of the Truecharge™ 2
Battery Charger will be connected to the correct terminals of the
battery (fuses or breakers) and from there to the positive terminals
of the battery. Make sure the negative terminal of the Truecharge™
2 Battery Charger will be connected to the battery negative terminal
(or DC negative bus). Do not reverse the connections.
WARNING: Fire and burn hazard
Make sure that the DC fuse and circuit breaker are open.
the DC battery cables.
cables using the crimp manufacturer’s instructions and
tool.
Installing the Truecharge™ 2 Battery Charger
To charger
2–17