DS4301U-200+T&R Maxim Integrated Products, DS4301U-200+T&R Datasheet - Page 7
![IC POT DIG NV 200K 32POS 8-USOP](/photos/1/39/13936/406-8-msop_sml.jpg)
DS4301U-200+T&R
Manufacturer Part Number
DS4301U-200+T&R
Description
IC POT DIG NV 200K 32POS 8-USOP
Manufacturer
Maxim Integrated Products
Datasheet
1.DS4301U-200.pdf
(7 pages)
Specifications of DS4301U-200+T&R
Taps
32
Resistance (ohms)
200K
Number Of Circuits
1
Memory Type
Non-Volatile
Interface
Increment/Decrement
Voltage - Supply
2.4 V ~ 5.5 V
Operating Temperature
-40°C ~ 85°C
Mounting Type
Surface Mount
Package / Case
8-MSOP, Micro8™, 8-uMAX, 8-uSOP,
Resistance In Ohms
200K
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Temperature Coefficient
-
Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are
implied. Maxim reserves the right to change the circuitry and specifications without notice at any time.
Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600 _____________________ 7
© 2003 Maxim Integrated Products
cycled to the device, the wiper setting that was just
stored is the setting loaded on power-up.
Wiper storage does not have to occur immediately after
a change in wiper position. At anytime the current wiper
position can be stored to the EEPROM by simply issu-
ing a low pulse to the CS pin for t
remains in a high state. The wiper does not move dur-
ing this action and the current wiper setting is stored in
EEPROM after t
For applications that require a specific wiper setting to
be loaded on power-up and never changed, write the
desired wiper setting to the EEPROM, then tie CS to
V
desired wiper setting is loaded from EEPROM, and
since CS is tied to V
the wiper setting.
There is a limit to the number of times the EEPROM can
be written to before a wear-out occurs (see the
Nonvolatile Memory Characteristics table). After EEP-
ROM wear-out occurs, the wiper can still be adjusted,
however accurately storing the wiper position is no
longer possible. When power is removed from the part,
the current wiper position is lost. Upon power-up, the
wiper setting stored in EEPROM is loaded within t
V
equal to V
the wiper setting that is loaded is unknown.
To achieve the best results when using the DS4301,
decouple the power supply with a 0.01µF or 0.1µF
capacitor. Use a high-quality ceramic surface-mount
capacitor when possible. Surface-mount components
minimize lead inductance, improving performace.
Ceramic capacitors tend to have adequate high-
frequency response for decoupling applications.
CC
CC
. Every time power is cycled to the DS4301, the
Nonvolatile, 32-Position Digital Potentiometer
reaching a stable voltage level greater than or
CC MIN
WST
Application Information
. If EEPROM wear-out has occurred,
.
CC
EEPROM Characteristics
, no changes can be made to
CLP
while the INC pin
Printed USA
WLT
of
TRANSISTOR COUNT: 3512
SUBSTRATE INFO: P-substrate
For the latest package outline information, go to
www.maxim-ic.com/DallasPackInfo.
is a registered trademark of Maxim Integrated Products.
Package Information
Chip Information