DD-9616BE-3A DENSITRON, DD-9616BE-3A Datasheet - Page 9

• Manufacturer Part Number: DD-9616BE-3A
• Description: PMOLED, 96*16, BLUE
• Manufacturer: DENSITRON

Specifications of DD-9616BE-3A

• Resolution: 96 X 16
• Viewing Area (h X W): 5.504mm X 23.104mm
• Pixel Size (h X W): 0.204mm X 0.204mm
• Voltage Rating: 2.8V
• Svhc: No SVHC (15-Dec-2010)
• Interface Type: Serial

3.3 INTERFACE PIN ASSIGNMENT
No.
10
11
12
13
14
1
2
3
4
5
6
7
8
9
Product No.
Copyright ©2009 DENSITRON TECHNOLOGIES plc. All rights reserved. – Proprietary Data
VCOMH
Symbol
VBREF
VBAT
RES#
VDD
IREF
SDA
VCC
C2N
C1N
VSS
SCL
C2P
C1P
DD-9616BE-2A
I/O
I/O
O
P
P
P
P
P
I
I
I
I
I
I
I
Positive Terminal of the Flying Inverting Capacitor
Negative Terminal of the Flying Boost Capacitor
The charge-pump capacitors are required between the terminals.
They must be floating when the converter is not used.
Power Supply for DC/DC Converter Circuit
This is the power supply pin for the internal buffer of the
DC/DC voltage converter. It must be connected to VDD source
when the converter is used. It should be floating to VDD when
the converter is not used.
Voltage Reference for DC/DC Converter Circuit
This pin is the internal voltage reference of booster circuit. A
stabilization capacitor should be connected to VSS
Ground of Logic Circuit
This is a ground pin. It acts as a reference for the logic pins. The
OEL driving voltages and the analogue circuits. It must be
connected to external ground.
Power Supply for Logic
This is a voltage supply pin. It must be connected to
external source
Power Reset for Controller and Driver
This pin is reset signal input.. When the pin is low, initialization
of the chip is executed.
I2C Bus Clock Signal
The transmission if information in the I2C bus is following a
clock signal. Each transmission of data bit is taken place during a
single clock period of this pin
I2C Bus Data Signal
This pin acts as a communication channel between the transmitter
and the receiver.
Current Reference for Brightness Adjustment
This pin is segment current reference pin. A resistor should be
connected between this pin and VSS. Set the current lower than
12.5μA.
Voltage Output High Level for COM Signal
This pin is the input pin for the voltage output high level for
COM signals. A capacitor should be connected between this pin
and VSS.
Power Supply for OEL Panel
This is the most positive voltage supply pin of the chip. It must
be connected to external source.
REV. A
Function
Page
9 / 24