1761015-1 TE Connectivity, 1761015-1 Datasheet - Page 2

• Manufacturer Part Number: 1761015-1
• Description: SFP Connector Cage
• Manufacturer: TE Connectivity

Specifications of 1761015-1

• Accessory Type: Connector Cage / Frame
• Connecting Termination: Press-Fit
• Rohs Compliant: Yes
• Product Type: Cage
• Termination Type: Press-Fit
• Configuration: 1 x 6
• Pcb Mount: Double Sided (Belly-to-Belly)
• Termination Post Length (mm [in]): 2.05 [0.081]
• Cage Plating: Tin over Nickel Flash
• Cage Type: Ganged
• Cage Material: Copper Alloy
• Lightpipe: Without
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant
• Application: SFP
• Packaging Method: Tray
• For Use With: Small Form-Factor Pluggable Connectors

3.3.
3.4.
3.5.
Rev C
Initial examination of product.
Final examination of product.
Dry circuit resistance.
Solderability.
Cable pull.
Durability
Height of latch.
Ratings
!
!
!
Performance and Test Description
Product is designed to meet the electrical, mechanical and environmental performance requirements
specified in Figure 1. Unless otherwise specified, all tests shall be performed at ambient environmental
conditions per EIA-364.
Test Requirements and Procedures Summary
Test Description
Voltage: 120 volts AC
Current: Signal application only
Temperature:
-55 to 85° C
Meets requirements of product
drawing.
Meets visual requirements.
35 milliohms maximum.
Solderable areas shall have a
minimum of 95% solder coverage.
100 N [22.5 lbf] minimum.
See Note.
See Note.
Change in height shall be 0.8 mm
[.031 in] maximum.
See Note.
Figure 1 (continued)
MECHANICAL
ELECTRICAL
Requirement
EIA-364.
Visual and dimensional inspection
per product drawing.
EIA-364.
Visual inspection.
EIA-364-23.
Subject mated specimens to 100
milliamperes maximum and 20
millivolts maximum open circuit
voltage.
EIA-638.
Load module with cable into a cage
soldered to a test board, with
attached bezel. Apply specified load
in axial direction, rotate cable 45
degrees from cable axis, and
remove load.
EIA-364-9.
Plug and unplug specimens for 100
cycles for two-piece specimens,
and 200 cycles for one-piece
specimens at a maximum rate of
600 cycles per hour with latch
retention feature operable.
Measure latch height.
Procedure
108-1950
2 of 5