5223004-2 TE Connectivity, 5223004-2 Datasheet - Page 6

• Manufacturer Part Number: 5223004-2
• Description: HARD METRIC CONNECTOR, RECEPTACLE, 60POS
• Manufacturer: TE Connectivity
• Series: Z-PACKr

Specifications of 5223004-2

• Connector Type: Backplane
• Row Pitch: 2mm
• Pitch Spacing: 2mm
• No. Of Contacts: 60
• Gender: Receptacle
• Contact Termination: Through Hole
• No. Of Rows: 5
• Contact Plating: Gold
• Rohs Compliant: Yes
• Product Type: Connector
• Pcb Mounting Orientation: Right Angle
• Post Type: Solder Post
• Module Type: Signal
• Voltage Rating (vac): 30
• Termination Post Length (mm [in]): 2.73 [0.107]
• Number Of Signal Positions: 60
• Sequencing: No
• Number Of Rows: 5
• Post Plating: Tin
• Centerline, Matrix (mm [in]): 2.00 x 2.00 [.079 x .079]
• Contact Type: Socket
• Contact Base Material: Phosphor Bronze
• Contact Plating, Mating Area, Material: Gold (30)
• Connector Style: Receptacle
• Housing Material: Liquid Crystal Polymer (LCP)
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Wave solder capable to 240°C, Wave solder capable to 260°C, Wave solder capable to 265°C, Reflow solder capable to 245°C, Reflow solder capable to 260°C, Pin-in-Paste capable to 245°C, Pin-in-Paste capable to 260°C
• Rohs/elv Compliance History: Always was RoHS compliant
• Applies To: Printed Circuit Board
• Application: Free-Board
• Lead Free Status / Rohs Status: Details

4.2.
4.3.
4.4.
Rev C
B.
Requalification Testing
If changes significantly affecting form, fit or function are made to the product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determined by development/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that the product meets requirements of Figure 1. Failures attributed
to equipment, test setup or operator deficiencies shall not disqualify the product. When product failure
occurs, corrective action shall be taken and samples resubmitted for qualification. Testing to confirm
corrective action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan will specify the sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with the applicable product drawing
and this specification.
2.
Test Sequence
Qualification inspection shall be verified by testing samples as specified in Figure 3.
Power connectors.
Power connector housings and contacts shall be prepared in accordance with applicable
Instruction Sheets and shall be selected at random from current production. All test groups
shall consist of 5 connectors each of the largest available size. All tests requiring individual
contact measurements shall be conducted on 30 contacts randomly selected over the 5
connectors. Test groups 1 and 2 shall be mounted on printed circuit boards designed to
accommodate vibration and physical shock fixturing providing a series circuit for all contacts
with access to measure termination resistance.
Contact Resistance Measurement Points
Figure 4
108-1441
6 of 8