MAX5851ETL+ Maxim Integrated Products, MAX5851ETL+ Datasheet - Page 18

• Manufacturer Part Number: MAX5851ETL+
• Description: IC DAC 8BIT DUAL 80MSPS 40-TQFN
• Manufacturer: Maxim Integrated Products

Specifications of MAX5851ETL+

• Settling Time: 12ns
• Number Of Bits: 8
• Data Interface: Parallel
• Number Of Converters: 2
• Voltage Supply Source: Single Supply
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 40-TQFN Exposed Pad
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Power Dissipation (max): -

Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are
implied. Maxim reserves the right to change the circuitry and specifications without notice at any time.
18
© 2004 Maxim Integrated Products
(The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information,
(The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information,
(The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information,
go to www.maxim-ic.com/packages.)
go to www.maxim-ic.com/packages.)
go to
Dual, 8-Bit, 80Msps, Current-Output DAC
____________________Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600
www.maxim-ic.com/packages.)
NOTES:
10. WARPAGE SHALL NOT EXCEED 0.10 mm.
1. DIMENSIONING & TOLERANCING CONFORM TO ASME Y14.5M-1994.
2. ALL DIMENSIONS ARE IN MILLIMETERS. ANGLES ARE IN DEGREES.
3. N IS THE TOTAL NUMBER OF TERMINALS.
4. THE TERMINAL #1 IDENTIFIER AND TERMINAL NUMBERING CONVENTION SHALL CONFORM TO JESD 95-1
5. DIMENSION b APPLIES TO METALLIZED TERMINAL AND IS MEASURED BETWEEN 0.25 mm AND 0.30 mm
6. ND AND NE REFER TO THE NUMBER OF TERMINALS ON EACH D AND E SIDE RESPECTIVELY.
7. DEPOPULATION IS POSSIBLE IN A SYMMETRICAL FASHION.
8. COPLANARITY APPLIES TO THE EXPOSED HEAT SINK SLUG AS WELL AS THE TERMINALS.
9. DRAWING CONFORMS TO JEDEC MO220, EXCEPT FOR 0.4mm LEAD PITCH PACKAGE T4866-1.
SPP-012. DETAILS OF TERMINAL #1 IDENTIFIER ARE OPTIONAL, BUT MUST BE LOCATED WITHIN THE
ZONE INDICATED. THE TERMINAL #1 IDENTIFIER MAY BE EITHER A MOLD OR MARKED FEATURE.
FROM TERMINAL TIP.
Printed USA
D
D/2
e
A1
A2
E/2
A
E
L1
(NE-1) X e
L
L
is a registered trademark of Maxim Integrated Products.
k
C L
(ND-1) X e
e
D2
C L
PACKAGE OUTLINE
36, 40, 48L THIN QFN, 6x6x0.8mm
PACKAGE OUTLINE
36, 40, 48L THIN QFN, 6x6x0.8mm
D2/2
e
21-0141
21-0141
Package Information
Package Information
Package Information
b
L
E2/2
C L
k
C L
e
E2
E
E
L
1
2
2
2