C1206C104J5RAC Cornell Dubilier Electronics (CDE), C1206C104J5RAC Datasheet - Page 2

• Manufacturer Part Number: C1206C104J5RAC
• Description: CAPACITOR CERAMIC, 0.1UF, 50V, X7R, 1206
• Manufacturer: Cornell Dubilier Electronics (CDE)

Specifications of C1206C104J5RAC

• Dielectric Characteristic: X7R
• Capacitance: 0.1µF
• Capacitance Tolerance: ± 5%
• Voltage Rating: 50VDC
• Capacitor Case Style: 1206
• No. Of Pins: 2
• Capacitor Mounting: SMD
• Rohs Compliant: Yes

* 60 PPM/ ºC below 10 pF nominal
+53 PPM –30 PPM/ºC from +25 ºC to –55 ºC comparable to MIL-C-20
Performance Characteristics
Temperature Characteristics:
Aging Rate:
Dissipation Factor:
Insulation Resistance (IR):
Moisture Resistance:
Post test limits @ 25 ºC, whichever is smaller
Immersion Cycling:
Post test limits @ 25 ºC
Life Test:
Post test limits @ 25 ºC
Dielectric Strength 2.5 times rated voltage for 5 seconds with current limited to 50 mA
CDE Cornell Dubilier • 1605 E. Rodney French Blvd. • New Bedford, MA 02744 • Phone: [phone] • Fax: [phone] • www.cde.com
Range ºC
Cap change without DC voltage
Test conditions @ 25 ºC
Limits:
After 2 min. electrification @ 25 ºC with rated voltage applied:
Method 106 (20 cycles w / 50 V applied)
(2 cycles @ 15 minutes each. Each cycle consists of immersion
in hot bath @ 65 ºC followed by immersion in cold salt water bath.)
Insulation Resistance, whichever is smaller..
Test Potential and Temperature
Capacitance Change, whichever is greater
Dissipation Factor
Insulation Resistance, whichever is smaller..
1000 Hrs
% C / Decade Hour, Max.
Parameter
MIL-STD-202, Method 104, Condition B
MIL-STD-202
≤100 pF w/ 1.0 vrms @ 1 MHz
>100 pF w/ 1.0 vrms @ 1 kHz w/ 1.0 vrms @ 1 kHz w/ 0.5 vrms @ 1 kHz w/ 1.0 vrms @ 1 kHz
1000 megohms x µF
100 megohms x µF
100 megohms x µF
100 megohms x µF
200% V @ 125 ºC
–55 ºC to +125 ºC
or 100 gigaohms
or 10 gigaohms
or 10 gigaohms
or 10 gigaohms
< 2% or 0.5 pF
COG (NPO)
0±30 PPM/ºC
0.10% Max.
0.25% Max.
0%
** X7R and Z5U dielectrics exhibit aging characteristics; therefore, it
is highly recommended that capacitors be de-aged for 2 hours at
+150 ºC and stabilized at room temperature for 48 hours before
capacitor measurements are made.
±15% of initial value** ±30% of initial value** ±30% of initial value**
1000 megohms x µF 1000 megohms x µF
100 megohms x µF 1000 megohms x µF
100 megohms x µF
100 megohms x µF 1000 megohms x µF
–55 ºC to +125 ºC
200% V @ 125 ºC
or 100 gigaohms
or 10 gigaohms
or 10 gigaohms
or 10 gigaohms
0.25% Max.
2.5% Max.
±15%
X7R
2.5%
100 megohms x µF
+10 ºC to +85 ºC
150% V @ 85 ºC
or 10 gigaohms
or 1 gigaohm
or 1 gigaohm
or 1 gigaohm
+22%, –56%
4.0% Max.
5.0% Max.
Z5U
5.0%
RoHS Compliant
3.5% 0603; 7.0% 0805
or 10,000 megohms
500 megohms x µF
or 1,000 megohms
or 1,000 megohms
or 1,000 megohms
10 megohms x µF
10 megohms x µF
10 megohms x µF
–30 ºC to +85 ºC
200% V @ 85 ºC
+22%, –82%
7.0% Max.
7.0% Max.
Y5V