S202SE2 Sharp Electronics, S202SE2 Datasheet - Page 9

• Manufacturer Part Number: S202SE2
• Manufacturer: Sharp Electronics

Specifications of S202SE2

• Input Type: DC
• Output Type: AC
• Input Voltage (max): 1.4V
• Output Voltage (max): 600V
• Input Current (max): 50mA
• Output Current: 8A
• Isolation Voltage: 3kV
• Package Type: SIP
• Output Device: Triac
• Pin Count: 4
• Mounting: Through Hole
• Operating Temp Range: -25C to 100C
• Operating Temperature Classification: Commercial
• Rad Hardened: No
• Lead Free Status / Rohs Status: Not Compliant

(a) Make sure there are no warps or bumps on the heat sink, insulation sheet and device surface.
(b) Make sure there are no metal dusts or burrs attached onto the heat sink, insulation sheet and device
(c) Make sure silicone grease is evenly spread out on the heat sink, insulation sheet and device surface.
Silicone grease to be used is as follows;
1) There is no aged deterioration within the operating temperature ranges.
2) Base oil of grease is hardly separated and is hardly permeated in the device.
3) Even if base oil is separated and permeated in the device, it should not degrade the function of a device.
Recommended grease : G-746 (Shin-Etsu Chemical Co., Ltd.)
In case the optional heat sink is screwed up, please solder after screwed.
In case of the lead frame bending, please keep the following minimum distance and avoid any mechanical
stress between the base of terminals and the molding resin.
Some of AC electromagnetic counters or solenoids have built-in rectifier such as the diode.
In this case, please use the device carefully since the load current waveform becomes similar with
rectangular waveform and this results may not make a device turn off.
Example how to equip optional heat sink for reinforced isolation
2) Case of the use of double isolation sheet (V
Please keep 5mm distance as minimum between naked metal portion of SSR and heat sink, and also
between naked metal portion of SSR and bis/nut/washer.
However, please avoid the natural rubber for isolation sheet.
1) Case of isolation sheet whose thickness is 0.4mm or more (V
surface.
: G-747 (Shin-Etsu Chemical Co., Ltd.)
: SC102 (Dow Corning Toray Silicone Co., Ltd.)
0.4mm thickness or more
isolation sheet
Isolation sheet
SSR
SSR
iso
: each 3kV or more)
9
4.4mm MIN.
Heat sink
Heat sink
iso
: 3kV or more)
S202SE2 Series
Sheet No.: D4-A03301EN