SLATAFL6GBJI STEC, SLATAFL6GBJI Datasheet - Page 39

• Manufacturer Part Number: SLATAFL6GBJI
• Manufacturer: STEC
• Type: ATA Cardr

Specifications of SLATAFL6GBJI

• Density: 6GByte
• Operating Supply Voltage (typ): 3.3/5V
• Operating Temperature (min): -40C
• Operating Temperature (max): 85C
• Package Type: Not Required
• Mounting: Socket
• Pin Count: 68
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (min): 3.18/4.75V
• Operating Supply Voltage (max): 3.465/5.25V
• Programmable: Yes
• Lead Free Status / Rohs Status: Not Compliant

SimpleTech P/N:
(where xxx=capacity; U=RoHS compliant lead-free; I=Ind. Op. Temp;
F=fixed device; S=small data packet optimized)
Write Multiple
(code: C5h)
This command is similar to the Write Sectors command.
Interrupts are not presented on each sector, but on the
transfer of a block which contains the number of sectors
defined by Set Multiple command.
Write Multiple without Erase
(code: CDh)
This command is similar to the Write Multiple command
with the exception that an implied erase before the write
operation is not performed. Note that before using this
command, it is required to erase the repective sectors using
the Erase Sectors command.
Write Sector(s)
(code: 30h or 31h)
This command writes from 1 to 256 sectors as specified in
the Sector Count register. A sector count of zero requests
256 sectors. The transfer begins at the sector specified in
the Sector Number register.
SLATAFLxxxJ(U)(I)-(F)(S)
Document Part Number 61000-02810-110 July 2005
Write Sector(s) without Erase
(code: 38h)
This command is similar to the Write Sector(s) command
with the exception that an implied erase before the write
operation is not performed. Note that before using this
command, it is required to erase the repective sectors using
the Erase Sectors command.
Write Verify
(code: 3Ch)
This command is similar to the Write Sector(s) command
except each sector is verified immediately after being written.
PC CARD
Page 39