LQ070Y3DG3A Sharp Electronics, LQ070Y3DG3A Datasheet - Page 16
![no-image](/images/manufacturer_photos/0/6/602/sharp_electronics_sml.jpg)
LQ070Y3DG3A
Manufacturer Part Number
LQ070Y3DG3A
Description
Manufacturer
Sharp Electronics
Datasheet
1.LQ070Y3DG3A.pdf
(22 pages)
Specifications of LQ070Y3DG3A
Lead Free Status / Rohs Status
Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
LQ070Y3DG3A
Manufacturer:
SHARP
Quantity:
1 000
11. Handling Precautions
a) Be sure to turn off the power supply when inserting or disconnecting the cable.
b) Be sure to design the cabinet so that the module can be installed without any extra stress such as warp or twist.
c) Since the front polarizer is easily damaged, pay attention not to scratch it.
d) Wipe off water drop immediately. Long contact with water may cause discoloration or spots.
e) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
f) Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface. Handle with care.
g) Since CMOS LSI is used in this module, take care of static electricity and injure the human earth when handling.
h) This module has its circuitry PCBs on the rear side and should be handled carefully in order not to be stressed.
i) Protect sheet(Laminate film) is attached to the module surface to prevent it from being scratched. Peel the sheet
j) The polarizer surface on the panel is treated with Anti-Glare for low reflection. In case of attaching protective
k) Do not expose the LCD module to a direct sunlight, for a long period of time to protect the module from the ultra
l) When handling LCD modules and assembling them into cabinets, please be noted that long-term storage in the
m) Liquid crystal contained in the panel may leak if the LCD is broken. Rinse it as soon as possible if it gets
n) Disassembling the module can cause permanent damage and should be strictly avoided.
o) Be careful when using it for long time with fixed pattern display as it may cause afterimage.
p) Adjusting volume have been set optimally before shipment, so do not change any adjusted value. If adjusted value
q) If a minute particle enters in the module and adheres to an optical material, it may cause display non-uniformity
Please insert for too much stress not to join FFC/FPC in the case of insertion of FFC/FPC.
Observe all other precautionary requirements in handling components.
off slowly just before the use with strict attention to electrostatic charges. Ionized air shall be blown over during
the action. Blow off the 'dust' on the polarizer by using an ionized nitrogen gun, etc. Working under the following
environments is desirable.
board over the LCD, be careful about the optical interface fringe etc. which degrades display quality.
violet ray.
environment of oxidization or deoxidization gas and the use of such materials as reagent, solvent, adhesive, resin,
etc. which generate these gasses, may cause corrosion and discoloration of the LCD modules.
inside your eye or mouth by mistake.
Please don't remove the fixed tape, insulating tape etc that was pasted on the original module.
(Except for protection film of the panel.)
(Please use a screen saver etc., in order to avoid an afterimage.)
is changed, the specification may not be satisfied.
・ All workers wear conductive shoes, conductive clothes, conductive fingerstalls and grounding belts
・ Use Ionized blower for electrostatic removal, and peel of the protect sheet with a constant speed. (Peeling of it
without fail.
at over 2 seconds)