NL2432HC22-22B NEC Electronics, NL2432HC22-22B Datasheet - Page 14
![no-image](/images/manufacturer_photos/0/4/471/nec_electronics_sml.jpg)
NL2432HC22-22B
Manufacturer Part Number
NL2432HC22-22B
Description
Manufacturer
NEC Electronics
Datasheet
1.NL2432HC22-22B.pdf
(24 pages)
Specifications of NL2432HC22-22B
Lead Free Status / Rohs Status
Not Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
NL2432HC22-22B
Manufacturer:
NEC
Quantity:
2
Company:
Part Number:
NL2432HC22-22B
Manufacturer:
NEC
Quantity:
1 000
Remark: Do not fold the FPC. When folding the FPC, pattern disconnection may be caused. In case of
YU,XR,YD,XL
XL
CATHODE
ANODE
bending FPC, the minimum curvature (R) must be more than 1.0 mm.
HCK
VCK
VOE
STB
HSP
VSP
Circuits of touch panel
Pin
AP
XL, YD, XR, YU
YU
YD
This pin synchronizes with the frame and the gate driver.
Fetching of display data starts when H is read at the rising edge of HCK.
This pin is the shift clock input of the gate shift register. The start pulse is captured at the rising
edge of clock and output the pulse at the falling edge.
Refer to the below “Circuits of touch panel”.
Refer to the below “Circuits of backlight”.
This pin turns on/off the BIAS circuit and turns on the output SW and amplifier. When AP is H,
the amplifier is set and the product is driving. The amplifier output and output SW are turned on
at the rising edge of AP, starting the product drive.
Note that the output SW is turned off at the rising edge of STB and the output becomes Hi-Z.
Connect “AP” to VCC, when the controller (part no.: S1L50282F23k100) is used.
This pin is the shift clock input of the column shift register. Display data is captured into the data
register at the rising edge.
This pin controls the output of the gate drivers. Output can be controlled regardless of VSP and
VCK.
A timing signal that latches the contents of the data register. When an H level is read at the rising
edge of HCK, the contents of the data register are latched and transferred to the D/A converter,
and analog voltage corresponding to the display data is output. Also, because the internal
operation via HCK continues even after the STB latch, do not stop HCK. The contents of the shift
register are cleared at the rising edge of STB.
DATA SHEET DOD-PD-0401 (4th edition)
XR
Description
Circuits of backlight
NL2432HC22-22B
Continued
Anode
Cathode
14