LS028B7UX01 Sharp Electronics, LS028B7UX01 Datasheet - Page 19

• Manufacturer Part Number: LS028B7UX01
• Manufacturer: Sharp Electronics

Specifications of LS028B7UX01

• Lead Free Status / Rohs Status: Compliant

(13)Handling Precautions
13-1) Insertion and taking out of FPCs
13-2) Handling of FPCs
13-3) Installation of the module
13-4) Precaution when mounting
13-5) Others
(1) If water droplets and oil attaches to it for a long time, discoloration and staining occurs.
Wipe them off immediately.
(2) Glass is used for the TFT-LCD panel. If it is dropped or bumped against a hard object,
(3)As the CMOS IC is used in this module, pay attention to static electricity when handling it.
(1) The liquid-crystal is deteriorated by ultraviolet rays. Do not leave it in direct sunlight and strong
(2) If it is kept at a temperature below the rated storage temperature, it becomes coagulated and the panel
(3) If the LCD breaks, don’t put internal liquid crystal into the mouth. When the liquid crystal sticks to the
(4) Wipe off water drop or finger grease immediately. Long contact with water may cause discoloration or spots.
(5) Observe general precautions for all electronic components.
On mounting the module, be sure to fix the module on the same plane. Taking care not to warp or
twist the module.
supply on the set side.
on the whole slit portion with bending radius larger than 0.6mm ,and only inner side (back side
of the module). Don’t bend it outer side (display surface side).
Take a measure for grounding on the human body.
Be sure insert and take out of the FPC into the connector of the set after turning off the power
Don’t give the FPCs too large force, for example, hanging the module with holding FPC.
ultraviolet rays for many hours.
may be broken. Also, if it is kept at a temperature above the rated storage temperature, it becomes isotropic
liquid and does not return to its original state. Therefore, it is desirable to keep it at room temperature as
much as possible.
hands, feet and clothes, wash it out immediately.
it may be broken. Handle it with sufficient care.
The FPC for LCD panel shall be bent only slit portion. The bending slit shall be bent uniformly
LCP-2707023－16