LU82551ITQ810 Intel, LU82551ITQ810 Datasheet - Page 31

• Manufacturer Part Number: LU82551ITQ810
• Manufacturer: Intel

Specifications of LU82551ITQ810

• Operating Supply Voltage (typ): 3.3V
• Operating Supply Voltage (min): 3V
• Operating Supply Voltage (max): 3.6V
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 196
• Lead Free Status / Rohs Status: Compliant

5.2.3
5.3
5.3.1
5.3.1.1
Datasheet
Proper operation requires that the system latency from the nominal PCI CLK to CLK_RUN#
assertion should be less than 0.5 µs. If the system latency is longer than 0.5 µs, there is an increase
in receive overruns. In these types of systems, the Clock Run functionality should be disabled. In
this case, the 82551IT will claim the PCI clock even during idle time. If the CLK_RUN# signal is
not used, it must be connected to a pull-down resistor.
Power Management Event
The 82551IT supports power management indications in the PCI mode. The PME# output pin
provides an indication of a power management event in PCI systems.
PCI Power Management
The 82551IT supports interesting packet wake-up and the capability to wake the system on a link
status change from a low power state. The 82551IT enables the host system to be in a sleep state
and remain virtually connected to the network. After a power management event or link status
change is detected, the 82551IT will wake the host system. The sections below describe these
events, the 82551IT power states, and estimated power consumption at each power state.
Power States
The 82551IT has one set of PCI power management registers and implements all four power states
as defined in the Power Management Network Device Class Reference Specification, Revision 1.0.
The four device power states, D0 through D3, vary from maximum power consumption at D0 to
the minimum power consumption at D3.
PCI transactions are only allowed in the D0 state, except for host accesses to the 82551IT’s PCI
configuration registers. The D1 and D2 power management states enable intermediate power
savings while providing the system wake-up capabilities. In the D3 cold state, the 82551IT can
provide wake-up capabilities only if auxiliary power is supplied. Wake-up indications from the
82551IT are provided by the Power Management Event (PME#) signal in PCI implementations.
D0 Power State
As defined in the Network Device Class Reference Specification, the device is fully functional in
the D0 power state. In this state, the 82551IT receives full power and should be providing full
functionality. In the 82551IT the D0 state is partitioned into two substates, D0 Uninitialized (D0u)
and D0 Active (D0a).
D0u is the 82551IT’s initial power state following a Power-on Reset (POR) event and before the
Base Address Registers (BARs) are accessed. Initialization of the CSR, Memory, or I/O Base
Address Registers in the PCI Configuration space switches the 82551IT from the D0u state to the
D0a state.
In the D0a state, the 82551IT provides its full functionality and consumes nominal power. In
addition, the 82551IT supports wake on link status change
While it is active, the 82551IT requires a nominal PCI clock signal (in other words, a clock
frequency greater than 16 MHz) for proper operation. During idle time, the 82551IT supports a PCI
•
The 82551IT asserts the CLK_RUN# signal to indicate that the PCI clock must prevent the
host from stopping or to request that the host restore the clock if it was previously stopped.
(Section 5.3.2, “Wake-up
Networking Silicon — 82551IT
Events”).
25