20-101-0356 Rabbit Semiconductor, 20-101-0356 Datasheet - Page 14
20-101-0356
Manufacturer Part Number
20-101-0356
Description
COMPUTER SINGLE-BOARD BL1800
Manufacturer
Rabbit Semiconductor
Datasheet
1.20-101-0356.pdf
(94 pages)
Specifications of 20-101-0356
Module/board Type
Single Board Computer Module
Product
Modules
Data Bus Width
8 bit
Processor Type
Rabbit 2000
Sram
128 KB
Flash
256 KB
Timers
8 bit, 10 bit
Number Of I/os
14
Backup Battery
3 V Lithium Coin Type
Operating Voltage
8 V to 40 V
Power Consumption
1.2 W
Board Size
89 mm x 64 mm x 19 mm
Description/function
Computer Module
For Use With/related Products
BL1800
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
316-1079
2.2.2 Connect Programming Cable
The programming cable connects the Jackrabbit to the PC running Dynamic C to down-
load programs and to monitor the Jackrabbit during debugging.
Connect the 10-pin connector of the programming cable labeled
the Jackrabbit board as shown in Figure 2. Be sure to orient the marked (usually red) edge
of the cable towards pin 1 of the connector. (Do not use the
for a normal serial connection.)
Connect the other end of the programming cable to a COM port on your PC.
10
NOTE: Use only the programming cable that has a red shrink wrap around the RS-232
NOTE: Never disconnect the programming cable by pulling on the ribbon cable.
NOTE: Some PCs now come equipped only with a USB port. It may be possible to use
level converter (Part No. 20-101-0513), which is supplied with the Development Kit.
Other Rabbit programming cables are not voltage-compatible or their connector sizes
may be different.
Carefully pull on the connector to remove it from the header.
an RS-232/USB converter (Part No. 20-151-0178) with the programming cable sup-
plied with the Jackrabbit Development Kit. Note that not all RS-232/USB converters
work with Dynamic C.
Figure 2. Power and Programming Cable Connections
to Jackrabbit Board
DIAG
PROG
connector, which is used
to header J3 on
Jackrabbit (BL1800)