DC-ME4-01T-JT Digi International, DC-ME4-01T-JT Datasheet - Page 22

• Manufacturer Part Number: DC-ME4-01T-JT
• Description: MODULE ME CUSTOMIZABLE JTAG
• Manufacturer: Digi International
• Type: Network Controller & Processorr

Specifications of DC-ME4-01T-JT

• Module/board Type: Device Server
• Data Rate: 11 Mbps
• Memory Type: Flash, SDRAM
• Interface Type: Ethernet
• Operating Voltage: 3.3 V
• Operating Current: 250 mA
• Maximum Power Dissipation: 825 mW
• Operating Temperature Range: - 40 C to + 85 C
• Board Size: 36.7 mm x 19.1 mm x 21.7 mm
• Data Bus Width: 32 bit
• Modulation: CCK, DBPSK, DQPSK
• Product: Modules
• Security: 64/128 bit WEP, TKIP, WPA, WPA2
• For Use With/related Products: Networking
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 602-1059

Embedded Module Connector, P10
Connectors and Blocks
Signal
GPIO-1
Pin
1
The development board provides the following connectors and blocks:






See the figure titled "Board Layout and Connector Locations:" on page 17 for the location
of the connectors and blocks. The following sections describe the connectors and blocks.
The Digi Connect ME embedded module Connector is a 20-pin female vertical header that
is labeled P10 on the development board. See the following figure for pin orientation; see
the following table for pin assignments.
Note:
Embedded Module Connector, P10
The Digi Connect Wi-ME module does not provide pins 1-6
JTAG Debugger Connector, P12.
-48V DC input to PoE module (ME must be connected to a Powering Device
for this feature.), P13
12V DC output from PoE module into Dev Board Power Supply, P14
Logic Analyzer Header, P3
GND
Pin
2
The figure shows the connector using the same orientation as shown in the
figure titled "Board Layout and Connector Locations:" on page 17.
GPIO-2
GPIO Port Pin Assignments
Pin
3
GND
Pin
4
GPIO-3 TXD_TTL GPIO-4 RXD_TTL GPIO-5
Pin
5
Pin
6
Pin
7
Pin
8
      
Pin
9
2 2