20-101-1112 Rabbit Semiconductor, 20-101-1112 Datasheet - Page 16

• Manufacturer Part Number: 20-101-1112
• Description: MODULE RABBITCORE RCM4010
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-1112

• Module/board Type: MPU Core Module
• Product: Microcontroller Modules
• Core Processor: Rabbit 4000
• Clock Speed: 58.98 MHz
• Interface Type: Ethernet, Serial
• Flash: 512 KB
• Timers: 10 x 8 bit, 1 x 10 bit, 1 x 16 bit
• Operating Supply Voltage: 3 V to 3.6 V
• Board Size: 47 mm x 61 mm x 20 mm
• Core: RCM4010
• Processor Series: RCM4000
• Silicon Manufacturer: Rabbit
• Core Architecture: Rabbit 4000
• Silicon Core Number: RCM4010
• Silicon Family Name: RCM4000
• Kit Contents: Board
• Development Tool Type: Hardware / Software - Dev Kit (Dev Tool)
• Rohs Compliant: Yes
• For Use With/related Products: RCM4010
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: Q3413688

2.2.3 Step 3 — Connect Programming Cable
The programming cable connects the module to the PC running Dynamic C to download
programs and to monitor the module during debugging.
Connect the 10-pin connector of the programming cable labeled
the RCM4000/RCM4010/RCM4050 as shown in Figure 4. Be sure to orient the marked
(usually red) edge of the cable towards pin 1 of the connector. (Do not use the
nector, which is used for a normal serial connection.)
Depending on the programming cable, connect the other end to a COM port or a USB port
on your PC.
10
NOTE: Never disconnect the programming cable by pulling on the ribbon cable.
NOTE: Either a serial or a USB programming cable was supplied with this Development
Carefully pull on the connector to remove it from the header.
Kit. If you have a serial programming cable, an RS-232/USB converter (Rabbit Part
No. 20-151-0178) is available to allow you to use the serial programming cable with a
USB port.
Figure 4. Connect Programming Cable and Power Supply
PROG
RabbitCore RCM4000
to header J1 on
DIAG
con-