10-497221-17D Amphenol, 10-497221-17D Datasheet - Page 231

• Manufacturer Part Number: 10-497221-17D
• Description: Terminals SKT 16L GA SOLDER
• Manufacturer: Amphenol

Specifications of 10-497221-17D

• Gender: Male
• Termination Style: Solder
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

230
Contact Amphenol Aerospace for more information at 800-678-0141 • www.amphenol-aerospace.com
Contact Insertion into the Connector
The following steps are recommended for assembly.
Contact Removal from the Connector
A contact is removed from the connector insert with the extraction tool as follows:
Panel Mounting
Amphenol
Aerospace
Assembly Instructions for MIL-DTL-26500
NOTE:
The Pyle Miniature Connector is designed with a unique sealing principle.
Assembly of contacts into the connector must be made with reasonable care to
avoid damage to the silicone rubber insert.
1. Lubricate wire cavities in back face of insert with a very thin film of DC-200
2. Locate contact in insertion tool (as shown in illustration).
3. Align contact with hole in rear face of insert. The alignment of insertion tool
4. Extract insertion tool, keeping it aligned with hole.
1. Set the spacer sleeve in the proper position for removal of male or female
2. Place tool over the contact and insert into front face of cavity. The alignment
3. Exert a nominal force axially (from 5 to 10 lbs.) to release retention collet.
4. Push extraction plunger to force the contact out of the rear of the insert.
5. Grasp contact or wire at rear face of insert and complete the extraction.
6. Remove extraction tool axially.
7. After using extraction tool the spacer sleeve should be set forward in last
Two receptacle shell styles, flange mount and D-hole mount, are available for
panel mounting. See the applicable drawings for mounting hole dimensions.The
square flange receptacle, sizes 10 through 22, is fastened to the panel with four
size #4-40 machine screws. The 24 and 28 size shells are fastened with #6-32
machine screws.
Silicone Oil or equal before inserting contacts.
with contact must be coaxial with the axis of the connector. When contact
has entered rear seal portion of insert, maintain alignment of contact and
tool parallel to, and in line with hole. Insert contact to full depth. Seating of the
contact in the retention collet is audible. The contact insertion force is less
than five pounds.
contact.
of removal tool with contact must be coaxial with axis of connector.
Spacer sleeve will shoulder at front face of insulation when tool is inserted to
proper depth.
notch to protect the end of the plunger guide.