20-101-0497 Rabbit Semiconductor, 20-101-0497 Datasheet - Page 21

• Manufacturer Part Number: 20-101-0497
• Description: MODULE OP6810 W/O ETH/MEM EXPANS
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-0497

• Module/board Type: Single Board Computer Module
• Product: Prototyping Accessories
• Processor Type: Rabbit 2000
• Sram: 128 KB
• Flash: 256 KB
• Timers: 8 bit, 10 bit
• Number Of I/os: 24
• Operating Voltage: 9 V to 36 V
• Power Consumption: 1.5 W
• Board Size: 111 mm x 91 mm x 33 mm
• For Use With/related Products: OP6810
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 20-101-497; 20-101-497

3.2 Digital I/O
3.2.1 Digital Inputs
The OP6800 has eight digital inputs, IN00–IN07, each with a current-limiting resistor of
27 kΩ, and protected over a range of –36 V to +36 V. The inputs are all pulled up to +5 V
as shown in Figure 9.
The OP6800 also has five digital inputs, IN08–IN12, each with a current-limiting resistor
of 12 kΩ, protected over a range of –25 V to +25 V, and pulled up to +5 V.
The actual switching threshold for IN00–IN12 is approximately 2.40 V. Anything below
this value is a logic 0, and anything above is a logic 1
IN13–IN17 are connected in parallel with five of the keypad buttons. These inputs are nor-
mally pulled up, but pulling one of these inputs down is the equivalent of pressing the cor-
responding keypad key remotely.
User’s Manual
NOTE: Remote keypad signal inputs IN13–IN17 are not protected, and can only
handle a voltage range from 0 to +5 V. These inputs were designed solely to
facilitate a remote keypad, and should not be used for other purposes.
Table 2. Remote Keypad Operation
Keypad Key
Figure 9. OP6800 Digital Inputs
6 (
0 (
1 (
2 (
3 (
)
)
)
)
)
Remote Keypad
Signal Inputs
IN13
IN14
IN15
IN16
IN17
.
17