101-0602 Rabbit Semiconductor, 101-0602 Datasheet - Page 86

• Manufacturer Part Number: 101-0602
• Description: COMPUTER SNGL BRD BL2500 44.2MHZ
• Manufacturer: Rabbit Semiconductor

Specifications of 101-0602

• Module/board Type: Single Board Computer Module
• For Use With/related Products: BL2500
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Follow these steps to build your wire harness.
1. Prepare a few lengths of wire about 30 cm (12") long. The wires should have different
2. Trim about 2–3 mm (0.1") of insulation from your wire.
3. Position the wire in the crimp terminal as shown in Figure C-1.
4. Use a crimp tool or pliers to first crimp the bare wire, then the insulation as shown in
5. Insert the crimp terminals with wires into the friction-lock connector with the tab on the
6. Repeat these steps until all the wires and crimp terminals have been assembled.
80
colors of insulation to facilitate identifying the connections.
Figure C-1.
crimp terminal facing the opening on the side of the friction-lock connector. Insert the
crimp terminal until the tab snaps into place in the side opening.
TIP: Use different wire colors to help you color-code your harness.
TIP: On 10-pin friction-lock connectors, insert a plug into the hole indicated in Figure C-2
to polarize your connector to help prevent offsetting the connector by one pin when you
attach it to your Coyote. Polarizing plugs are not included in Rabbit’s Connectivity Kit.
Figure C-2. Insert Crimp Terminals Into Friction-Lock Connector
Figure C-1. Crimp Wire in Crimp Terminal
Coyote (BL2500)