DC-ME-01T-C-50 Digi International, DC-ME-01T-C-50 Datasheet - Page 13
![no-image](/images/manufacturer_photos/0/1/193/digi_international_sml.jpg)
DC-ME-01T-C-50
Manufacturer Part Number
DC-ME-01T-C-50
Description
ME 8MB SDRAM 2MB FLASH 50 PAK
Manufacturer
Digi International
Specifications of DC-ME-01T-C-50
Module/board Type
Device Server
For Use With/related Products
Networking
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
DC-ME-01T-C-50
Manufacturer:
Digi International
Quantity:
135
Connectors: Ethernet Interface
A b o u t t h e D i g i C o n n e c t M E & D i g i C o n n e c t W i - M E E m b e d d e d M o d u l e s
Note
The Ethernet connector is an 8-wire RJ-45 jack that meets the ISO 8877 requirements for
10/100BASE-T. See the following figure and table for pin orientation and pin assignments.
Note
The development board provides a reference design of a POE (Power Over
Pin orientation and assignments are the same for modules with or without a
Ethernet) power supply. A schematic for this reference design is installed by
the setup program on the CD.
JTAG connector.
Power and Device Interface Connector Pin Assignments
17-19
Pin
11
12
13
14
15
16
20
CTS / GPIO 2
DSR / GPIO 3
DCD / GPIO 1
RESET
+3.3V
GND
—
/INIT
Signal
Digi Connect Wi-ME
Clear to Send (Input) / GPIO
Data Set Ready (Input) / GPIO
Data Carrier Detect (Input) / GPIO
Reset
Power
Ground
Reserved. Do not connect.
Software Reset
Description
5