SINet HUb 444 Applied Motion, SINet HUb 444 Datasheet - Page 2

• Manufacturer Part Number: SINet HUb 444
• Description: Stepper Motors MOTOR CONTROL
• Manufacturer: Applied Motion

Specifications of SINet HUb 444

• Dimensions: 106.6 mm
• Step Angle: 1.8 deg
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

SiNet Hub Technical Specifications
Power ......................................................... Power is provided by Si™ indexer-drive on Port 1. Provides up to
Communication .......................................... Ports 1 - 4: RS232, 9600 bps, 8 data bits, one stop bit, no parity.
Physical ...................................................... Constructed on .062˝ fiberglass printed circuit board with 4 .156˝
Program. .................................................... Move distances: +/- 16,000,000 steps
Connectors ................................................. RJ11 for drives and PC/MMI. Screw terminals for programmable
Programmable Inputs ................................ Optically isolated, 2200 ohms internal impedance, 5–24 VDC.
Programmable Outputs .............................. Optically isolated (photo darlington), 28 VDC max, 100 mA max.
SiNet Hub 444 Technical Drawings
MECHANICAL OUTLINE:
1
2
3
4
HUB 444
IN
4.2"
OUT
PC-MMI
50 mA for MMI via PC/MMI port.
MMI: same.
PC in router mode: same.
PC when running SiNet Programmer software: 19200 bps.
Max cable length, any port: 50 feet.
mounting holes (nylon spacers included).
4.2˝ x 2.85˝ x 0.72˝.
Two red LEDs.
Operating temperature range: 0 - 70 C.
Optional DIN rail mounting kit (fits ENS0022 35 mm rail).
Move speeds: .025 to 50 rev/sec
Accel/Decel range: 1 to 3000 rev/sec/sec
Time delays: .01 to 300 seconds
Loop counts: 1 to 65,535
Number of nested loops: unlimited
Number of subroutines: unlimited
Subroutine stack depth: 5 calls maximum
Number of comments: limited only by 200 line program length
MMI variables for storing speeds, distances and loop counts en-
tered by operator: 50
Maximum size of messages displayed by an MMI Prompt: 60
characters (80 for an MMI Menu instruction)
Maximum total size of all MMI Prompt messages: 1500 characters
Steps/revolution: 2,000 - 50,800 (200 - 50,800 with Si-100 indexer)
inputs and outputs. Accept AWG 16-28 wire.
2.85"
BLOCK DIAGRAM:
IN1
IN2
IN3
IN4
831/761-6555 • 800/525-1609 • FAX [phone]
Isolation
Optical
Host
PLC
PC
or
404 Westridge Dr. • Watsonville, CA 95076
www.appliedmotionproducts.com
Isolation
Optical
drive #1
drive #2
drive #3
drive #4
OUT1
OUT2
OUT3
OUT4
CONTROLS
MOTOR
215